Baja SAE rear suspension design

Nick Brockman

2013-05-03

Abstract:The University of Cincinnati is participating in 2013 Baja SAE design competition, which is a competition that takes place each year and is made up of at least 3 international competitions. This paper will describe the design process and performance of the rear suspension of the 2013 Bearcat Baja vehicle. INTRODUCTION The Society of Automotive Engineers (SAE) holds international design competitions each year where universities design, build and compete against other universities. The premise of the competition is to design and build an off-road vehicle that is to be used in an offroad competition series. The vehicles are to be designed to be cost effective and durable enough to compete in a series of competitions. All of the vehicles in this hypothetical series will be powered by the same stock Briggs and Stratton engine so the design of the vehicle is ultimately what determines the vehicles performance. The Baja SAE competitions include an evaluation by SAE representatives to judge the overall design of the vehicle. Then each universities vehicle will compete in a series of competitions leading up to a 4 hour off-road endurance race. The rear suspension is integral for the vehicles’ dynamic handling, speed, braking ability and durability. REAR SUSPENSION SYSTEM DESIGN PROBLEM STATEMENT The rear suspension of the Bearcat Baja SAE vehicle needs to be light weight while remaining strong. It must permit sufficient travel to clear the obstacles presented by the competition. The suspension should maximize camber adjustability for best results. RESEARCH – The initial design was to have double wishbones for the rear suspension. The double wishbone design however would lead to the distance from the firewall to the rear axel being longer than our desired length of 20.5’’ for ease of camber adjustability. DESIGN GOALS – The main factors for the design of the rear suspension are weight, cost and functionality. The rear suspension was identified to be the trailing arm members, 2 rear linkages per side, bearing carriers, tires and rims, as well as the necessary hardware. The allotted weight for this system is 50 lbs. Since the rims and tires for the rear would be included in the weight of the rear suspension the design needs to be light weight. The team wanted to utilize Fox Air Shocks for the vehicle, these will cut down on weight as they do not have steel springs that traditional suspensions use. As this vehicle is designed to be an off-road racing vehicle it is important that the suspension is adjustable so the vehicle can be set up for different situations. The vehicle design specifications that directly affect the design of the rear were determined in initial team meetings. These vehicle specifications are as follows:  Rear Track Width: 54’’

Engineering,Materials Science