Abstract:ABSTRACT The suspension is a very important subsystem of a vehicle as it affects both passenger ride comfort and the handling properties of the vehicle. This paper concentrates on two important aspects of suspension system design. One is the fine tuning of a passive suspension system design through an optimisation study using a virtual suspension system model. The second is the design and testing of an active suspension controller. Both problems are treated here in a computer aided setting using a highly realistic suspension system and a full vehicle model, respectively. INTRODUCTION The main reason for the existence of a suspension system like that shown in Figure 1 can be thought of as isolating the driver and passengers of a vehicle from the vibrations induced by road irregularities. This, however, is not the only reason for the use of a suspension system. According to Bastow and Howard (1993), maintaining contact between the wheels and the road surface is a far more fundamental issue as the vehicle's control and stability depends on it. So, suspension design requires concentration not only on ride comfort but also on handling characteristics. As ride and handling requirements are in conflict with each other, the design of suspension system characteristics like effective stiffness and damping require the determination of a compromise solution. While the well known quarter car model and higher order lumped parameter models used to represent the vehicle's overall suspension system are useful for preliminary work and initial design, suspension design work of any practical use has to take into account the physical details of the suspension system being used (double wishbone or McPherson strut type for example). While academic optimisation studies on suspension design and active suspension controller design can concentrate on the quarter car model (Cole, 2001; Yagiz and Yuksek, 2001), one needs to base these optimisation and controller design studies on a much more accurate model of the vehicle's suspension system to be able to transfer the results to the automotive industry. Fortunately, such accurate models are quite readily implementable in the form of canned multibody dynamics programs like Adams® (Anon., 2001) and Simpack (Kortum) or special purpose vehicle dynamics programs like Vedyna (Anon., 2000). The latter approach is taken in this paper. The suspension systems used are highly realistic models formed in Adams/Car® (Anon., 2001). This paper focuses on optimisation of suspension parameters and ride and handling properties and on implementation of active suspension control using an Adams/Car® suspension model. A first step in a suspension optimisation study is to determine which suspension variables can be varied and their

Design and Kinematics Analysis of Suspension System for a Formula Society of Automotive Engineers (FSAE) Car

Kinematics Simulation and Optimization of Double Wishbone Front Suspension for a FSAE Car

Kinematic and Structural Analysis of Independent type suspension system with Anti-Roll bar for Formula Student Vehicle

Simulation and optimization of FSAE racing suspension

Design and Optimization of FSAE Race Car suspension system

Stiffness Design, Analysis and Validation of a Parallel-Mechanism Equivalent Suspension System

Design of Upper A Arm of Double Wishbone Suspension System

Optimization of a FSAE Racing Car's Front Suspension Based on ADAMS

Design of a Double Wishbone Baja SAE Suspension System

Analysis of a front suspension system for UniART FSAE car using FEA

Analysis of Passenger Car Suspension System Using Adams

Dynamic Analysis of Car Suspension Using ADAMS/Car for Development of a Software Interface for Optimization

USE OF COMPUTER AIDED METHODS FOR OPTIMISATION IN VEHICLE SUSPENSION DESIGN AND FOR DESIGNING ACTIVE SUSPENSIONS

Multi-objective optimization of the kinematic behaviour in double wishbone suspension systems using genetic algorithm

Suspension and tyre loads estimation of an FSAE car: model development and on-track validation

The Analysis and Optimization on the Front Suspension System of a Formula Racing Car Based on ADAMS

Fatigue Reliability Assessment of the New Design of Rear Suspension System of the JCU Motorsport Car

Suspension system design for a vehicle under BAJA SAE parameters

Kinenatic Analysis and Simulation of Automobile Double-Wish Bone Suspension

Teaching automotive suspension design to engineering students: Bridging the gap between CAD and CAE tools through an integrated approach