Abstract:Solid-electrolyte interface (SEI) is "the most important but least understood (component) in rechargeable Li-ion batteries". The ideal SEI requires high elastic strength and can resist the penetration of a Li dendrite mechanically, which is vital for inhibiting the dendrite growth in lithium batteries. Even though Li2CO3 and Li2O are identified as the major components of SEI, their mechanical properties are not well understood. Herein, SEI-related materials such as Li2CO3 and Li2O were electrochemically deposited using an environmental transmission electron microscopy (ETEM), and their mechanical properties were assessed by in situ atomic force microscopy (AFM) and inverse finite element simulations. Both Li2CO3 and Li2O exhibit nanocrystalline structures and good plasticity. The ultimate strength of Li2CO3 ranges from 192 to 330 MPa, while that of Li2O is less than 100 MPa. These results provide a new understanding of the SEI and its related dendritic problems in lithium batteries.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c13732.TEM images of growth, compression, and tensile tests of the Li2CO3 and Li2O nanorods; the SAED and EELS of the Li2CO3 and Li2O nanorods; the growth rate–time plot of the Li2CO3 and Li2O nanorods; force–deformation data corresponding to the compression of the Li2CO3 and Li2O nanorods; inverse finite element simulation derived stress–strain data for the Li2CO3 and Li2O nanorods (PDF)In situ TEM movie showing the growth of a Li2CO3 nanorod (corresponding to Figure 1). The Li2CO3 grew directly along the CNT. The movie was recorded at 5 frames/s in TEM bright-field images and played at 312× speed (AVI)In situ TEM movie showing the growth of a Li2CO3 nanorod (corresponding to Figure S1). The Li2CO3 grew directly along the CNT. The movie was recorded at 5 frames/s in TEM bright-field images and played at 84× speed (AVI)In situ TEM movie showing the compression of a Li2CO3 nanorod (corresponding to Figure 2). The movie was recorded at 5 frames/s in TEM bright-field images and played at 12× speed (AVI)In situ TEM movie showing the compression experiment of a Li2CO3 nanorod (corresponding to Figure S3). The movie was recorded at 5 frames/s in TEM-bright field images and played at 5× speed (AVI)In situ TEM movie showing the growth of a Li2O nanorod (corresponding to Figure S6). The Li2O grew directly along the CNT. The movie was recorded at 5 frames/s in TEM bright-field images and played at 34× speed (AVI)In situ TEM movie showing the compression of a Li2O nanorod (corresponding to Figure 3a). The movie was recorded at 5 frames/s in TEM bright-field images and played at 22× speed (AVI)In situ TEM movie showing the compression of a Li2O nanotube (corresponding to Figure 3e). The movie was recorded at 5 frames/s in TEM bright-field images and played at 30× speed (AVI)This article has not yet been cited by other publications.

In Situ Measurements of the Mechanical Properties of Electrochemically Deposited Li2CO3 and Li2O Nanorods.

In Situ Measurements of the Mechanical Properties of Electrochemically Deposited Li 2 CO 3 and Li 2 O Nanorods

Probing Mechanical Properties of Solid-Electrolyte Interphases on Li Nuclei by In Situ AFM

Lithiation of SiO2 in Li-ion Batteries: in Situ Transmission Electron Microscopy Experiments and Theoretical Studies.

Interfacial Lithiation Induced Leapfrog Phase Transformation in Carbon Coated Se Cathode Observed by In-Situ TEM

Nanostructural and Electrochemical Evolution of the Solid-Electrolyte Interphase on CuO Nanowires Revealed by Cryogenic Electron Microscopy and Impedance Spectroscopy.

Tunable structure and dynamics of solid electrolyte interphase at lithium metal anode

Direct in situ measurements of electrical properties of solid–electrolyte interphase on lithium metal anodes

Direct in-situ measurement of electrical properties of solid electrolyte interphase on lithium metal anode

Resolving nanostructure and chemistry of solid-electrolyte interphase on lithium anodes by depth-sensitive plasmon-enhanced Raman spectroscopy

Computational Exploration of the Li-Electrode|Electrolyte Interface in the Presence of a Nanometer Thick Solid-Electrolyte Interphase Layer

Atomistic investigation of solid electrolyte interphase: nanostructure, chemical composition and mechanical properties

Direct observation of inhomogeneous solid electrolyte interphase on MnO anode with atomic force microscopy and spectroscopy.

Nanoscale Visualization of Lithium Plating/Stripping Tuned by On‐site Formed Solid Electrolyte Interphase in All‐Solid‐State Lithium‐Metal Batteries

Evaluating Solid-Electrolyte Interphases for Lithium and Lithium-free Anodes from Nanoindentation Features

In situ quantification of interphasial chemistry in Li-ion battery

In Situ and Quantitative Characterization of Solid Electrolyte Interphases

Study of the formation and evolution of solid electrolyte interface via in-situ electrochemical impedance spectroscopy

Nanostructure of the Interphase Layer between a Single Li Dendrite and Sulfide Electrolyte in All-Solid-State Li Batteries

Understanding Solid Electrolyte Interphase (SEI) Species at the Electrode-Electrolyte Interface in Liquid Lithium Metal Batteries Via in-Situ Fourier Transform Infrared (FTIR) Spectroscopy

In Situ AFM Imaging of Solid Electrolyte Interfaces on HOPG with Ethylene Carbonate and Fluoroethylene Carbonate-Based Electrolytes.