Abstract:Abstract Cutting temperature is playing a key role in evaluating the cutting process, which significantly affects the tool wear and the quality of the workpiece. Aiming at the problems of low precision, low aging, and poor stability of cutting temperature measurement on the front tool face, an integrated design and production scheme of a high sensitivity built-in wireless temperature measurement tool was proposed. The temperature distribution position on the front tool face was analyzed with 3D finite element simulation software, and the thermal contact position of the main and secondary film thermocouples was determined. SiO2 insulated films and NiCr/NiSi film thermocouples were prepared on the front tool surface by femtosecond laser micromachining, electrolyte-plasma polishing, plasma enhanced chemical vapor deposition and magnetron sputtering, and a static calibration experiment system for sensitivity and accuracy of the temperature measuring tool for the film thermocouple was established, and Seebeck coefficient of the film thermocouple was obtained. According to the actual cutting conditions, the wireless temperature measuring system of the thin film thermocouple tool was built and the field cutting test was carried out to obtain the influence law of different cutting parameters on the cutting temperature, and further verify the feasibility of the thin film temperature measuring sensor. The research results show that: Seebeck coefficients of the two kinds of thermocouples prepared by the NiCr/NiSi thin film thermocouple temperature measuring tool are 34.97 μV/°C and 34.96 μV/°C, and the slope of the temperature data fitting curve is 1.00398 and 0.997475, respectively. The linear correlation coefficient R2 is close to 1, which is close to the standard K-type thermocouple, which shows good sensitivity and accuracy. At the same time, the temperature measurement results are close to the commercial standard K thermocouple, and the error is less than 5%, indicating that the developed film thermocouple has a high measurement accuracy and can meet the needs of temperature measurement. Actual cutting test is carried out with developed wireless temperature measuring device of thin film thermocouple, which shows this device can meet the requirements of tool temperature measurement, and the feasibility of thin film temperature measuring sensor is further verified. The research provide technical reference for industrial intelligent manufacturing in order to realize the wireless measurement of cutting area temperature of tool front.

An integrated and intelligent milling temperature sensing tool holder with electromagnetic energy harvesting system

Cutting Temperature and Force Data Acquisition and Measuring System Design in High Speed Machining

Dynamical Temperature Monitoring System Design for High-speed Cutting Based on Thin-film Thermocouples

A Real-Time Cutting Temperature Monitoring of Tool in Peripheral Milling Based on Wireless Transmission

An Integrated Wireless Vibration Sensing Tool Holder for Milling Tool Condition Monitoring

Research on a Power Management System for Thermoelectric Generators to Drive Wireless Sensors on a Spindle Unit.

A Power Management System For Thermoelectric Generators Used On Spindle Units Of Machine Tools

An Integrated Wireless Vibration Sensing Tool Holder for Milling Tool Condition Monitoring with Singularity Analysis

Heat Exchanger Design for A Thermoelectric Module to Drive Wireless Sensors in Spindle Monitoring

A multi-sensor integrated smart tool holder for cutting process monitoring

A Wireless Temperature Measuring System For Rotating Spindle Based On Zigbee

Design of a Vibration-Sensing Tool Holder for High-Quality Signal Measurement in Milling Process

CUTTING TEMPERATURE MEASUREMENT IN HIGH-SPEED END MILLING

Development and testing of a wireless smart toolholder with multi-sensor fusion

A Wireless Data Acquisition and Transmission System for Smart Tool Holder Based on Socket

Power Output Characterization Assessment of Thermoelectric Generation in Machine Spindles for Wireless Sensor Driving

Cutting tool wear monitoring based on a smart toolholder with embedded force and vibration sensors and an improved residual network

Integrated design and fabricate of high sensitivity built-in thin-film thermocouple temperature measurement tool

Wireless Self-Powered Vibration Sensor System for Intelligent Spindle Monitoring

A Locally Boron-Doped Diamond Tool for Self-Sensing of Cutting Temperature: Lower Thermal Capacity and Broader Applications

A Novel Smart Toolholder with Embedded Force Sensors for Milling Operations