Abstract:We present an experimental study on the drag reduction by polymers in Taylor-Couette turbulence at Reynolds numbers ($Re$) ranging from $4\times 10^3$ to $2.5\times 10^4$. In this $Re$ regime, the Taylor vortex is present and accounts for more than 50\% of the total angular velocity flux. Polyacrylamide polymers with two different average molecular weights are used. It is found that the drag reduction rate increases with polymer concentration and approaches the maximum drag reduction (MDR) limit. At MDR, the friction factor follows the $-0.58$ scaling, i.e., $C_f \sim Re^{-0.58}$, similar to channel/pipe flows. However, the drag reduction rate is about $20\%$ at MDR, which is much lower than that in channel/pipe flows at comparable $Re$. We also find that the Reynolds shear stress does not vanish and the slope of the mean azimuthal velocity profile in the logarithmic layer remains unchanged at MDR. These behaviours are reminiscent of the low drag reduction regime reported in channel flow (Warholic et al., Exp. Fluids, vol. 27, issue 5, 1999, p. 461-472). We reveal that the lower drag reduction rate originates from the fact that polymers strongly suppress the turbulent flow while only slightly weaken the mean Taylor vortex. We further show that polymers steady the velocity boundary layer and suppress the small-scale Görtler vortices in the near-wall region. The former effect reduces the emission rate of both intense fast and slow plumes detached from the boundary layer, resulting in less flux transport from the inner cylinder to the outer one and reduces energy input into the bulk turbulent flow. Our results suggest that in turbulent flows, where secondary flow structures are statistically persistent and dominate the global transport properties of the system, the drag reduction efficiency of polymer additives is significantly diminished.

Prediction and New Insight for the Drag Reduction of Turbulent Flow with Polymers and Its Degradation Mechanism.

A note to further explain the mechanism of turbulent flow drag reduction by polymer from chemistry view

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Precise prediction of the drag reduction efficiency of polymer in turbulent flow considering diameter effect

Experimental research on drag reduction by polymer additives in a turbulent pipe flow

Global drag reduction and local flow statistics in Taylor-Couette turbulence with dilute polymer additives

Coherent structure dynamics and identification during the multistage transitions of polymeric turbulent channel flow

Drag Reduction Induced by Polymer in Turbulent Pipe Flows

Turbulent drag reduction in plane Couette flow with polymer additives: a direct numerical simulation study

Turbulent Drag Reduction in Plane Couette Flow Wit H Polymer Additives: a Direct Numerical Simulation Study

Polymer-Induced Drag Enhancement in Turbulent Taylor-Couette Flows: Direct Numerical Simulations and Mechanistic Insight

Colloquium: Theory of Drag Reduction by Polymers in Wall Bounded Turbulence

A low-Reynolds-number k–ε model for polymer drag-reduction prediction in turbulent pipe flow

Negative differential resistance due to the resonance coupling of a quantum-dot dimer

Review of Research on Mechanism of Drag Reduction by Polymer Additives

Boundary Conditions and Polymeric Drag Reduction for the Navier–Stokes Equations

Statistics and spectral analysis of turbulent duct flows with flexible and rigid polymer solutions

Direct Numerical Simulation on Drag-Reducing Flow by Polymer Additives Using A Spring-Dumbbell Model

The correspondence between drag enhancement and vortical structures in turbulent Taylor–Couette flows with polymer additives: a study of curvature dependence

Maximum Drag Enhancement Asymptote in Turbulent Taylor–Couette Flow of Dilute Polymeric Solutions

Turbulent duct flow with polymers