Abstract:Interaction between microwave power, used for local heating and mode control, and density fluctuations can produce a broadening of the injected beam, as confirmed in experiment and simulation. Increased power deposition width could impact suppression of tearing mode structures on ITER. This work discusses the experimental portion of an effort to understand scattering of injected microwaves by turbulence on the DIII-D tokamak. The corresponding theoretical modeling work can be found in M.B. Thomas et. al.: Submitted to Nuclear Fusion (2017)[Author Note - this paper to be published in same journal]. In a set of perturbative heat transport experiments, tokamak edge millimeter-scale fluctuation levels and microwave heat deposition are measured simultaneously. Beam broadening is separated from heat transport through fitting of modulated fluxes. Electron temperature measurements from a 500 kHz, 48-channel ECE radiometer are Fourier analyzed and used to calculate a deposition-dependent flux. Consistency of this flux with a transport model is evaluated. A diffusive and convective transport solution is linearized and compared with energy conservation-derived fluxes. Comparison between these two forms of heat flux is used to evaluate the quality of ECRF deposition profiles, and fitting finds a significant broadening of 1D equilibrium ray tracing calculations from the benchmarked TORAY-GA ray tracing code is needed. The physical basis, cross-validation, and application of the heat flux method is presented. The method is applied to a range of DIII-D discharges and finds a broadening factor of the deposition profile width which scales linearly with edge density fluctuation level. These experimental results are found to be consistent with the full-wave beam broadening measured by the 3D full wave simulations in the same discharges.

Toroidal injection angle dependence of EC assisted plasma initiation at DIII-D

Recent Experiment Results During Electron Cyclotron Heating On Hl-2a

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Towards Model-Based Current Profile Control at DIII-D

Resolving ECRH deposition broadening due to edge turbulence in DIII-D by heat deposition measurement

Breakdown Assisted By A Novel Electron Drift Injection In The J-Text Tokamak

Decoupling of peeling and ballooning thresholds of pedestal stability and reduction in ELM frequency via enhanced turbulence with edge electron cyclotron heating in DIII-D

Isotope impact on Alfvén eigenmodes and fast ion transport in DIII-D

Experimental research of ECW pre-ionization and assisted startup in EAST

Modeling of the ECCD injection effect on the Heliotron J and LHD plasma stability

Core electron temperature turbulence and transport during sawtooth oscillations in the DIII-D tokamak

Investigation of Core Transport Barriers in DIII-D Discharges with off-axis Te Profile Peaks

ELM-free Enhanced Dα H-mode with Near Zero NBI Torque Injection in DIII-D Tokamak

Evolutions of Zonal Flows and Turbulence in A Tokamak Edge Plasma During Electron Cyclotron Resonance Heating

Broadening of electron cyclotron power deposition and driven current profiles caused by dissipative diffractive propagation

Core inductive electric field during sawtooth crashes on DIII-D

Investigation of core transport changes in DIII-D discharges with off-axis T e profile peaks

The Dependence of the Impurity Transport on the Dominant Turbulent Regime in ELM-y H-mode Discharges

Radiation induced non-linear oscillations in ITER baseline scenario plasmas in DIII-D

Experimental and numerical modeling of plasma start-up assisted by electron drift injection on J-TEXT