Abstract:In order to achieve bidirectional high strain rate dynamic tension of materials or structures, based on the elastic stress wave propagation theory in bending bars and the principle of the Hopkinson bar, a symmetrical herringbone bending bar was designed. The designed structure can generate and transmit two compression waves at the same time, and convert them into two-way tension waves propagating along the tension bar through the contact adapters. In order to understand the influence of the herringbone bending bar geometric configuration on the propagation of elastic compression waves, the dynamic analysis and ABAQUS finite element analysis (FEA) were carried out for the device. The study shows that after the square compression elastic wave propagates through the bending bar, the platform section of the square wave will incline in high front and low back, and as the bending angle increases, the slope is larger, and the waveform distortion caused by the large curvature rod is more serious. In order to realize the platform segment of the square wave or trapezoidal wave, the tapered impact bar is optimized so that it can be used to generate load waves with low front and high back to offset the tilt distortion in the transmission. In the end, to verify the feasibility and effect of the bidirectional dynamic tensile loading device based on the bidirectional bending Hopkinson bar, a small verification device was built. The results show that the device realized bidirectional tension loading for the pulse width of about 54 μs with good synchronization, the time difference between the starting point of the two waves was less than 2.5 μs, and the amplitude difference was less than 6×10−6. The bidirectional tensile test was carried out on the 2024 aluminum alloy samples, and the good test results were obtained. This confirms that the proposed method can be used for bidirectional dynamic tension and lays the foundation for the expansion of the device to biaxial tensile loading.

Temperature control system and method for true triaxial dynamic and static combined loading Hopkinson pressure bar

POSITIONING AND CENTERING SYSTEM AND METHOD FOR TRUE TRIAXIAL HOPKINSON PRESSURE BAR

The Split Hopkinson Pressure Bar Technique of High Temperatures and Its Application

A New Technique for Conducting Split Hopkinson Tensile Bar Test at Elevated Temperatures

An Advanced Pneumatic Firing Mechanism for the Split Hopkinson Bar Equipment

Theoretical Instructions for Experimenting Controllable Hopkinson Pressure Bar

On a Bidirectional Bending Hopkinson Tension Test Method

A New Method of Tensile Performance Testing for Materials at High Temperature and High Strain Rate

Some Fundamental Problems Concerning the Measurement Accuracy of the Hopkinson Tension Bar Technique

The Extended Application of Hopkinson Bar Technique

Validity analysis of materials' dynamic tensile SHTB experimental technique at ultrahigh temperature

Design of a Continuously Repeated Impact Method with Constant Amplitude Based on Hopkinson Bar: Principle and Impact Fatigue Life Testing

Study on Overloading-resistibility of Initiator and Energetic Materials Based on the Technique of Hopkinson Pressure Bar

Dynamic and static combined electromagnetic loading Hopkinson rock bar wave propagation testing device

A critical assessment of high-temperature dynamic mechanical testing of metals

Investigation on Experimental Method of Low-Impedance Materials Using Modified Hopkinson Pressure Bar

A New Technique for Performing Tortional Split Hopkinson Bar Experiments at High Temperatures

High-temperature SHPB Experimental Technique and Its Application

Dynamic Behavior of Concrete under Static Triaxial Loading Using 3D-Hopkinson Bar

Determination of Dynamic Behavior of Materials at Elevated Temperatures and High Strain Rates Using Hopkinson Bar

High Temperature SHPB System with Heat Insulation for Short Ceramic Bars