Abstract:Three-dimensional (3D) printing has broad application prospects in the field of lightweight composite structures due to its superior manufacturing flexibility. However, current 3D-printed continuous fiber-reinforced thermoplastic (CFRTP) parts and components suffer from poor mechanical properties due to processing defects that arise from poor resin impregnation in fiber bundles. Impregnation only occurs when the resin is molten. Hence, the evolution of the thermal field in the local space being printed is critical to determine the degree of resin impregnation. In this paper, we presented a new method to regulate the transient 3D thermal field during printing via an external laser heat source, thus effectively improving the resin impregnation of 3D-printed CFRTPs. To reveal their quantitative relations, the 3D thermal field and consequent impregnation behavior of resin in fiber bundles were numerically modeled. Furthermore, a process-dependent multiscale mechanical model was developed to investigate the tensile strength of 3D-printed composites based on the impregnation analysis framework. The parameters in the proposed models were determined experimentally. The thermal model was demonstrated and validated experimentally through thermocouple measurements. The impregnation percentage and tensile strength of the printed samples were determined using microscopy and tensile testing, respectively. Simulation results agreed well with experimental data, indicating the good accuracy of the proposed modeling methods. The findings provide insights into the process-impregnation-property relationship in 3D printing of CFRTP structures. Based on these findings, an effective method has been proposed to reduce printing defects and improve manufacturing efficiency by improving the thermal field.

Multiscale Model of the RTM Process: From Mesoscale Anisotropic Permeability of Woven Structures to Macroscale Resin Impregnation

Progressive failure analysis of 2D woven composites at the meso-micro scale

The Multi-Scale Flow Behaviors of Sisal Fiber Reinforced Composites During Resin Transfer Molding Process

Study on Void Formation in Multi-Layer Woven Fabrics

Effect of Nesting on the Out-Of-Plane Permeability of Unidirectional Fabrics in Resin Transfer Molding

Meso-Macro Simulations of the Forming of 3D Non-Crimp Woven Fabrics

Numerical prediction strategy of fabric in‐plane permeability considering realistic inter‐ and intra‐tow geometry

Interpretation of 3‐D Permeability Measurements for RTM Modeling

Statistical characterization of fiber permeability for composite manufacturing

Effect of Layer Shifting on the Out-of-Plane Permeability of 0 degrees/45 degrees Alternative Multilayer Fabrics

The Interaction Between Micro- and Macro-Scopic Flow in RTM Preforms

New set-up for measurement of permeability properties of fibrous reinforcements for RTM

Multiscale Numerical and Experimental Investigation into the Evolution of Process-Induced Residual Strain/stress in 3D Woven Composite

Model Prediction and Experimental Validation of Transverse Permeability of Large-Tow Carbon Fiber Composites

Process-dependent Multiscale Modeling for 3D Printing of Continuous Fiber-reinforced Composites

Sensor Fusion for Simultaneous Estimation of In-Plane Permeability and Porosity of Fiber Reinforcement in Resin Transfer Molding

Multiscale Modeling of the Mechanical Behavior of 3D Braided CFRP Composites under Uniaxial Tension

Experimental and Numerical Analyses of the In-plane Permeability of 2.5D-Woven Carbon Fabric Preforms with Compressive Deformation

Numerical Simulation of the Influence of Fibrous Structure on Resin Filling in RTM Process

Geometry Modeling and Permeability Prediction for Textile Preforms with Nesting in Laminates

Investigation of Transport Property of Fibrous Media: 3D Virtual Modeling and Permeability Calculation