Simultaneous Measurement of Torque and Position of a Motor Operated Valve Actuator Using a Fiber Bragg Grating Sensor Embedded into the Surface of the Worm Shaft

T Li,Y Tu,X Yu,J Zhang,YL Wang,ST Tu,S Chen,C Qi

DOI: https://doi.org/10.1007/978-3-030-64908-1_35

2020-01-01

Abstract:Continuous and proper operation of valves is essential for reliable operation and safety of power and petrochemical plants, especially nuclear power plants. Two of very important operating parameters of a motor operated valve (MOV) need to be measured are the torque and position of a valve stem produced by an actuator. A method of employing a fiber Bragg grating (FBG) sensor embedded into the surface of a worm shaft by epoxying to measure the axial force induced in the worm is proposed for measuring the torque and position of an MOV actuator which is indicative of the torque and position of a valve stem, where the axial force is proportional to the torque and periodically changes with the worm rotating. The strain characteristics of the FBG sensor are evaluated by uniaxial tensile testing to assure adequate strain transfer to the grating. The response of the sensor to the axial loads acting on the worm is linear with high repeatability and strain transfer efficiency. A test system capable of inducing a variety of adjustable torsional loads on an actuator is provided for determining its torque and position. The response of the sensor to the actuator output torque is also linear, while the periodical changes in the Bragg wavelength of the sensor during actuator operation make it possible to obtain the position of a valve stem simultaneously. The results demonstrate that this method provides a great potential for simultaneous measurement of the torque and position of valves in power and process industries.