Abstract:Monitoring rotor blade vibrations is imperative in aero-engine testing and service. Blade tip timing (BTT), a promising technique for such monitoring, assesses the operational status of rotor blades through non-intrusive measurement of blade tip displacement. Traditional BTT technology relies on the Once-Per-Revolution (OPR) probe, which poses installation challenges and introduces measurement uncertainties in practical applications. This paper introduces a novel OPR-free approach, employing Adaptive Variable Reference Blades (AVRB) for non-intrusive measurement of rotor blade vibrations. The method assumes a stochastic mistuning of blades within the same stage, resulting in non-simultaneous resonance of blades at a given speed. In each revolution, the vibration level of individual blades is determined by assessing the deviation between the average speed of a blade, as measured by two adjacent BTT probes, and the average speed across the entire circumference. Consequently, a non-vibrating blade is adaptively identified and selected as the reference blade. The relative vibration levels among blades vary dynamically during different revolutions, influenced by mistuning features, leading to variability in the reference blades. These adaptive variable reference blades can then replace the OPR probe, aiding in the computation of vibration displacement and further parameter identification of blades. To validate the effectiveness of the proposed method, a five-degree-of-freedom numerical model is utilized for simulation. Additionally, experiments involving both a five-bladed disk and an eight-bladed disk are conducted to validate the proposed approach. Numerical simulations and two sets of test results demonstrate a fundamental agreement between the blade vibration displacement calculated using the proposed method and the outcomes obtained through the traditional BTT method with OPR. The relative error in the identified blade vibration frequency derived from the blade vibration displacement, as determined by both methods, does not exceed 1 %. Additionally, the relative error in the amplitude of the blade vibration displacement is within the range of 10 %.

Optimal Placement of Blade Tip Timing Sensors Considering Multi-mode Vibration Using Evolutionary Algorithms

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

Experimental Study on the Optimization of the Sensor Arrangement for Blade Tip Timing Measurement

Physical Constraints Fused Equiangular Tight Frame Method for Blade Tip Timing Sensor Arrangement

Single-Probe Blade Tip Timing: A Novel Method for Anomaly Identification Based on Frequency Shift.

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

Parameter Identification Based on Iterative Signal Space in Blade Tip Timing

OPR-free Single Probe Blade Tip Timing for Monitoring Rotating Blade

A Novel Blade Vibration Monitoring Experimental System Based on Blade Tip Sensing.

Blade Tip Timing for Multi-Mode Identification Based on the Blade Vibration Velocity

Spatial Transformation of General Sampling-Aliasing Frequency Region for Rotating-Blade Parameter Identification with Emphasis on Single-Probe Blade Tip-Timing Measurement

Adaptive Iterative Approach for Efficient Signal Processing of Blade Tip Timing

A Novel OPR-free Method for Blade Tip Timing Based on Adaptive Variable Reference Blades

An OPR-Free Blade Tip Timing Method for Rotating Blade Condition Monitoring

Optimization and assessment of blade tip timing probe layout with concrete autoencoder and reconstruction error

Parameter Identifications of Synchronous Vibration of Rotating Blades with Large Amplitude Based on Blade Tip Timing

Rotating blade frequency identification by single-probe blade tip timing

Measurement Methodology: Blade Tip Timing: A Non-Contact Blade Vibration Measurement Method

Single-probe Blade Tip Timing Based on Sparse Bayesian Learning

Blade Tip Timing Signal Filtering Method Based on Sampling Aliasing Frequency Map

Active Aliasing Technique and Risk Versus Error Mechanism in Blade Tip Timing