Abstract:The measurement of contact characteristics of the spindle–holder taper interface is critical for the evaluation of the performance of a machine tool spindle system. In this study, an ultrasonic method was proposed to measure the contact stiffness and pressure distribution on the taper interface. The taper interface was scanned by an ultrasound transducer, and the nominal contact area was directly estimated from the resulting ultrasonic reflection coefficient. The normal stiffness distribution was determined by the spring-damper model from the reflection coefficient. On this basis, the distributed and global radial stiffness of the taper interface was calculated by the presented theoretical formulas. Meanwhile, a calibration curve was established to convert the ultrasonic reflection to contact pressure. Based on the proposed ultrasonic method, the effects of angle fitting error and clamping force were studied. The results show that the contact area, contact pressure and contact stiffness increase with the clamping force. As the angle fitting error increases, the contact area decreases, while the pressure and stiffness at the big end of the taper interface become much larger than these at the small end. In the meantime, the global radial stiffness increases first and then decreases. This result suggests that a larger angle fit error within the permissible range is better for the global radial stiffness. Moreover, the measured results confirm that a taper joint with an angle fit error larger than +36" is not suitable for practical application, because the contact pressure at the small end is too small. To compare with the ultrasonic method, the geometrical shape profiles of the contact surfaces were constructed, and FE models were also established for contact pressure predictions. The comparison shows that the ultrasound results are consistent with the surface shape profiles and the numerical predictions. Besides, one of the taper interfaces was measured three times with the same clamping force, and the results indicate that the repeatability of the proposed method is good.

A Calibration Ultrasound Method to Estimate Contact Characteristics at Spindle-Holder Interface

Ultrasonic measurement of contact stiffness and pressure distribution on spindle-holder taper interfaces

Finite Element Analysis of Spindle Thermal Character Based on Thermal Contact Resistance

Modelling and Characteristic Investigation of Spindle-Holder Assembly under Clamping and Centrifugal Forces

A novel approach for preload measurement and analysis of fixed position preload spindle

Transmission and measurement characteristics evaluation of surface acoustic wave sensor on rotating spindle in machine tools

Simulation and the Experimental Test of Radial-Deformation of Spindle-Tool-holder Connection System at High-Speed

Characteristics of stiffness and contact stress distribution of a spindle-holder taper joint under clamping and centrifugal forces

Ultrasonic Measurement of Contact Stress of Tiny Interference Components

Contact Analysis of HSK Toolholder-Spindle Interface

A fully analytical nonlinear dynamic model of spindle-holder-tool system considering contact characteristics of joint interfaces

Investigation on the Influence of Interference Fit on the Static and Dynamic Characteristics of Spindle System

Modeling and Experimental Study on Static Characteristic of BT Tool Holder-Spindle Interface

A virtual material-based static modeling and parameter identification method for a BT40 spindle–holder taper joint

Study on the 2D Equivalent Simulation Model of Bearing and Spindle for Precision Machine Tools

A New Dynamic Calibration Method For Integrated Force-Measuring Tool Holder

Stiffness Modeling, Identification, and Measuring of a Rotating Spindle

In-Process Measurement of Contact Pattern Variations in Rotating Main Bearing of Machine Tools Using Ultrasonic Waves Method.

Analytical Modeling Method of Dynamics for the Spindle Rotor System

A High Accuracy Method for the Field Dynamic Balancing of Rigid Spindles in the Ultra-Precision Turning Machine

Study on Effect of Spindle on Dynamic Performance and Surface Quality of Whole Machine Tool