Abstract:Abstract A number of experimental studies have been performed to study the effect of geometric and aerodynamic parameters on the film cooling performance on the flat plate and turbine blade, however, the experimental investigations on a fully-cooled turbine vane is limited, especially at different density ratios. Consequently, an experiment on a fully-cooled turbine vane with multi-row film cooling holes was carried out to investigate the effect of mass flow ratio and density ratio on the film cooling performance, in which the film cooling effectiveness and heat transfer coefficient was measured by transient liquid crystal. The mainstream inlet Reynolds number based on the inlet velocity and the true chord length is 120000 and the mainstream turbulence intensity is 15%, three mass flow ratios of 5.5%, 8.4% and 11% and two density ratios of 1.0 and 1.5 were tested. The air was selected as the mainstream, the air and carbon dioxide were independently selected as secondary flow to produce two density ratios of 1.0 and 1.5. The test vane is similar in geometry to a first stage turbine vane of a normal aeroengine. Two cavities were manufactured in the test vane to feed 18 rows of film cooling holes. Results show that with the mass flow ratio increasing for DR = 1.0 and 1.5, the film cooling effectiveness on pressure side gradually increases, however, that on the suction side gradually decreases. Generally, increased density ratio produces higher film cooling effectiveness because the injection momentum was reduced, however, the film cooling effectiveness on the suction side for DR = 1.5 is lower than that for DR = 1.0. The coolant outflow significantly enhances the surface heat transfer coefficient for 0 < S/C < 0.5 and S/C < −0.5. The heat transfer coefficient in the leading edge is less affected by the density ratio, however, the increase in density ratio reduces the heat transfer coefficient ratio in other regions, especially for large mass flow ratios.

Heat Transfer Characteristics Analysis on a Fully Cooled Vane With Varied Density Ratios

Film Cooling and Heat Transfer Performance of a Fully-Cooled Turbine Vane at Varied Density Ratios and Mass Flow Ratios

Heat transfer characteristic of a fully cooled turbine vane

Film Cooling Performance of a Fully Cooled Vane at High Subsonic Conditions

AN EXPERIMENTAL INVESTIGATION OF FULL-COVERAGE FILM COOLING CHARACTERISTICS OF A TURBINE GUIDE VANE

Experimental Study of Effects of Mass Flow Ratio on Film Cooling Effectiveness on Full Surface Cooling Vane

An Experimental Investigation Of Full-Coverage Film Cooling Effectiveness And Heat Transfer Coefficient Of A Turbine Guide Vane In A Linear Transonic Cascade

Heat Transfer Coefficient and Film Cooling Effectiveness on a Full-Film Cooling Vane

Experimental Study on Film Cooling and Heat Transfer Characteristics of a Twisted Vane with Staggered Counter-Inclined Film-Hole and Laid-Back-shaped-hole

Measurements of Heat Transfer Coefficient and Film Cooling Effectiveness Distribution on a Vane Using Transient Liquid Crystal Technique

Numerical Study on Flow and Heat Transfer of a Cooled First Stage Vane of a Gas Turbine

Flow and heat transfer on the pressure side of C3X vane with various cooling hole blockages

NUMERICAL STUDY ON FILM COOLING CHARACTERISTICS OF C3X VANE WITH WAVE-TRENCH HOLE

Experiments of flow and heat transfer performances for air-cooling laminated turbine vane

Investigation on the effect of hole diameter and wall thickness on the overall cooling effectiveness of turbine vane leading edge

Experimental and Numerical Investigations on the Heat Transfer of Film Cooling With Cylindrical Holes Fed With Internal Coolant Cross Flows

Effect of Mass Flow Ratios on the Conjugate Heat Transfer of a Metal Turbine Vane at Medium Temperature

Numerical analysis of vane endwall film cooling and heat transfer with different mainstream turbulence intensities and blowing ratios

Experimental and numerical investigations of vane endwall film cooling with different density ratios

Effects of blowing ratio on turbine vane suction side film cooling under different turbulence intensity conditions

Experimental Investigation of Heat Transfer Characteristics on Turbine Endwall with Full Coverage Film Cooling