Flow and heat transfer on the pressure side of C3X vane with various cooling hole blockages
Huwei Dai,Wenxin Dong,Xiaolei Liu,Peng Zhang,Xueling Zhang,Junhong Zhang,Jiewei Lin
DOI: https://doi.org/10.1016/j.ijthermalsci.2024.109007
IF: 4.779
2024-03-14
International Journal of Thermal Sciences
Abstract:Performance of film cooling under blockage has been extensively studied on flat plates. However, the ideal film cooling patterns obtained from flat plates may not be directly applicable to realistic engineering applications involving curved vanes or surfaces. The pressure gradient on a curved surface can significantly alter the behavior and trajectory of the coolant jet. This can result in variations in film cooling effectiveness and heat transfer characteristics compared to flat plate configurations. Therefore, in this study, a conjugate heat transfer numerical simulation was performed on the C3X vane under three sorts of cooling hole blockages including all-round blockage (RB), leading-edge blockage (LB), and trailing edge blockage (TB) with blockage ratio of 0.2, 0.35 and 0.5, respectively. Results show that RB changes the cooling effectiveness in the mid-span section nonlinearly, the cooling effectiveness was decreased by (0.019, 0.023, 0.038). LB is found beneficial to local film cooling downstream the cooling hole near the mid-span and tip area of a vane at blockage ratio of 0.2 with an increment of 0.021 in the mid-span section and 0.013 in 86% span section. As the blockage ratio increases to 0.35 and 0.5, LB produces adverse influences and the mid-span cooling effectiveness was decreased by 0.013 and 0.043, respectively. TB riseed the cooling hole outlet temperature marginally. The cooling effectiveness near the hole outlet in the mid-span section was decreased by (0.020, 0.034, 0.024). However, under blockage ratio of 0.2 and 0.35, the coolant jet is found to reattach the vane surface, resulting in improved film cooling effectiveness.
engineering, mechanical,thermodynamics