Abstract:The numerical simulation of the air flow of the room equipped with the crossflow fan air conditioners has been conducted a lot. However, the simulation of the air flow distribution under the heating mode has always been difficult to match the experimental data well, due to the fact that both the air temperature and the flow are affected by the buoyancy. In addition, very few full-scale simulations were conducted. To precisely predict the air flow and temperature distribution of the room with the crossflow fan air conditioner, a full-scale steady numerical simulation was conducted with the Computational Fluid Dynamics (CFD) package. The full-scale physical model was constructed strictly according to the real settings, including the detailed components of the air-conditioner, such as the crossflow fan and the heat exchangers. The Shear-Stress Transport (SST) k-ω turbulent model was selected to simulate the low Reynold flow near the inner surface of the room, and to simulate the high Reynold and transitional flow near the fan blades of the air-conditioner. The porous medium model was used to simulate the heat exchange fins in the air-conditioner. Furthermore, an experiment under the same condition was also conducted to verify the accuracy of the simulation. Results showed that the simulated supply air flow rate was 537.48 m 3 /h, producing a 4.97% deviation from the experiment result. Meanwhile, the upward movement of the supply air from the outlet of the air-conditioner was observed, leading to higher air temperatures in the upper region of the room. Furthermore, among all 210 measured temperature data points in the room, 149 data points had the deviation within ±5%, and 194 data points had the deviation within ±10%. 9 abnormal data points with greater deviation near the door were detected, which might be resulted from the outdoor cold air leakage through the crack between the door and the floor in the experiment. Conclusively, the full-scale numerical simulation in this study produced an accurate and reliable solution to predict the air temperature distribution in buildings, thus providing a potential method for the design or optimization of the air-conditioners.

ENHANCING UNIFORMITY OF AIRFLOW AND TEMPERATURE DISTRIBUTION FOR PRODUCE COOLING IN A COLD ROOM BASED ON FIELD SYNERGY PRINCIPLE

Enhanced airflow by additional axial fans for produce cooling in a cold room: A numerical study on the trade-off between cooling performance and irreversibility

Optimization of air flow field for direct air cooling units

Multi-fanning and its improvement of thermal and wind comfort: An auxiliary means to air conditioning

Optimization air-conditioning system and thermal management of data center via fan-wall free cooling technology

Numerical Analysis of Air Supply Alternatives for Forced-Air Precooling of Agricultural Produce

Experimental and Numerical Study of Cross-flow Fan in Air-conditioner Indoor Unit

Full-scale numerical simulation and experimental validation of the thermal environment under the heating mode in an air-conditioned room

A study about the demand for air movement in warm environment

Evaluation, Monitoring, and Improving the Airflow and Heat Transfer in a Cold Storage of Foodstuffs, CFD Simulation and Experimental Investigation

Experimental and Numerical Investigations of Indoor Air Movement Distribution with an Office Ceiling Fan

Scale modeling study of airflow distribution uniformity in large spaces with high heat flux

Optimization of airflow organization in fan-wall data center via baffles

CFD Simulation and Uniformity Optimization of the Airflow Field in Chinese Solar Greenhouses Using the Multifunctional Fan–Coil Unit System

Cooling effect of air movement on heating performances of advanced air distribution

Applicability of elevated air movement for maintaining thermal comfort in warm environments

Air Distribution Optimization Of Impingement Freezer

An Experimental Study on Energy-saving Control of Multi-fan Cooling Module

Experimental Performance Comparison and Trade‐off among Air‐based Precooling Methods for Postharvest Apples by Comprehensive Multiscale Thermodynamic Analyses

Implementation of Demand-Oriented Ventilation with Adjustable Fan Network

Numerical and experimental investigation on the integrate performance of axial flow cooling fan and heat exchanger