Abstract:Due to the possibility of putting a large number of modules consisting of switches and capacitors connected in series, the modular multilevel converter (MMC) can easily be scaled to high power and high voltage power conversion, which is an attractive feature for filter-less and transformer-less design and helpful to achieve high efficiency. However, a significantly increased amount of sub-modules in a MMC may increase the requirements for sensors and also increase the risk of failures. As a result, fault detection and diagnosis of MMC sub-modules are of great importance for continuous operation and post-fault maintenance. Therefore, in this paper, an effective fault diagnosis technique for real-time diagnosis of the switching device faults covering both the open-circuit faults and the short-circuit faults in MMC sub-modules is proposed, in which the faulty phase and the fault type is detected by analyzing the difference among the three output load currents, while the localization of the faulty switches is achieved by comparing the estimation results by the adaptive observer. In contrast to other methods that use additional sensors or devices, the presented technique uses the measured phase currents only, which are already available for MMC control. In additional, its operation, effectiveness and robustness are confirmed by simulation results under different operating conditions and load conditions.

Sliding Mode Observer Based Robust Fault Reconstruction for Modular Multilevel Converter with Actuator and Sensor Fault

Sliding Mode Observer Design for Discrete-Time Nonlinear Uncertain Systems Via Sliding Mode Prediction

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Sliding-mode observer design for a class of uncertain system

Observer-Based Sliding Mode Control for Markov Jump Systems with Actuator Failures and Asynchronous Modes

Sliding Mode Observers and Their Application in Fault Diagnosis

Detection and Isolation of Multiple Faults in a Modular Multilevel Converter Based on a Sliding Mode Observer

Robust sliding‐mode observer‐based multiple‐fault diagnosis scheme

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM

Open-circuit Fault Detection and Isolation for Modular Multilevel Converter Based on Sliding Mode Observer

Multiplicative Faults Detection and Reconstruction in Linear Dynamic Systems Using Robust Sliding Mode Observers

Diversified Diagnosis Strategy for PMSM Inter-Turn Short-Circuit Fault Via Novel Sliding Mode Observer

Online Fault Identification Based on an Adaptive Observer for Modular Multilevel Converters Applied to Wind Power Generation Systems

Actuator fault detection and reconstruction in the uncertain dynamical system

Actuator Fault Reconstruction in a Class of Uncertain Dynamic Systems with Mismatched Uncertainties

Centralized Sensor Fault Reconstruction of DC Microgrids Based on Sliding Mode Observer

Fault reconstruction of descriptor nonlinear system based on sliding mode observer

Observer-based Fault Reconstruction for Linear Systems Using Adaptive Sliding Mode Method.

Robust Fault Detection Scheme for Asynchronous Switched Systems via Sliding Mode Observer

Sliding mode observer-based fault reconstruction for uncertain descriptor linear systems

Real-Time Sensor Fault Identification and Remediation for Single-Phase Grid-Connected Converters Using Hybrid Observers With Unknown Input Adaptation