Abstract:The operating conditions and the properties of the liquid have great effects on the shape and size of the liquid film and eventually affect the efficiencies of the atomization of alternative fuels, liquid jet impingement cooling, and equipment cleaning processes. The shape and size of the liquid film are dominated by the distance from the stagnation point to the liquid film edge(rmax). In this study, after deducing the thickness profile and the theoretical rather than the numerical solution of the initial velocity profile of the liquid film, a set of semi-empirical models about the shape, size of the liquid film, and the width of the raised zone formed by an oblique jet impinging on curved walls have been developed. In order to validate the theoretical model, a corresponding experiment has been developed, in which the jet velocities, impingement angles, liquid viscosity, surface tension, and radius of curvature have been included. The comparisons showed the theoretical results are in good agreement with the experimental data. The error for the location of the inner and outer border lines are less than 14.9% and 13.5%, respectively, except for the location in the upstream part of the film. And the effects of jet velocity, impingement angle, surface tension, dynamic viscosity, and radius of curvature were also theoretically discussed. The outer border line of the liquid film is dominated by the impingement angle and the impingement velocity, which affect the rmax exponentially and linearly, respectively. And the liquid viscosity and surface tension coefficient also affect the rmax approximately linearly. But the effects of the liquid viscosity and surface tension coefficient on the rmax are much less than the impingement velocity. The radius of curvature has little effect on the outer border lines and width of the raised zone when gravity is ignored.

Effect of surface contact angle on the wall impingement of a power-law liquid jet

Experimental and numerical study of liquid film by jet impingement: Based on contact angle model

Oblique Collision of Two Power-Law Fluid Jets at Low Speed

Experimental and Analytical Study on the Liquid Film by Jet–Wall Impingement

Analytical Consideration of Liquid Droplet Impingement on Solid Surfaces

Liquid Sheet Formed by a Newtonian Jet Obliquely Impinging on Pro/hydrophobic Surfaces

Effect of Liquid Layer on the Motion of Particle During Oblique Wet Collision

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

Liquid Sheet Formed by Impingement of Two Viscous Jets

Interaction of liquid films formed by two continuous jets impinging obliquely on a vertical wall

The Liquid Film Behaviors Created by an Inclined Jet Impinging on a Vertical Wall

Universality of Droplet Impingement: Low-to-High Viscosities and Surface Tensions

THE SHAPE AND THICKNESS OF THE LIQUID FILM FORMED BY THE OBLIQUE IMPINGEMENT OF MULTIPLE JETS ONTO A WALL

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Numerical Study on Impingement of a Droplet upon a Liquid Film

Effective water/water contact angle at the base of an impinging jet

Semi-empirical Model for the Liquid Fuel Film Formed by an Oblique Jet Impinging on a Curved Wall

Effects of Cavitation and Hydraulic Flip on Liquid Film Formed by Jet Impinging on the Wall

Study of the thickness of the liquid film formed by a round water jet impinging on a curved cylindrical wall

Analyses on the Splashing Parameters of High-Speed Oil Impacted A Wall in Jet Lubrications