Abstract:Microbial corrosion is a widespread problem in nature， and the construction industry is included， particularly in microbial-rich areas such as sewage treatment facilities and marine buildings. Microbial growth in different environments will have different significant effects on the microstructure and macroscopic properties of concrete， but there appears to be no published literature on the effects of sulfur-oxidizing bacteria on concrete performance in a seawater environment. In this study， concrete specimens were semi-submerged in seawater containing microorganisms， and the changes in biofilm thickness and the number of microorganisms within the film at the gas-liquid-solid interface of concrete at different corrosion ages were analysed using optical microscopy and ultraviolet optical density （OD）. The evolution of the surface morphology of concrete was recorded using a general video camera， a VHX-600e ultra-deep field microscope， a YAW-2000J pressure tester and scales to test the changes in compressive strength and mass of concrete specimens， and the NJ-DTL-6 concrete chloride ion electric flux tester was used to measure the electric flux of concrete specimens. Samples were also taken at the gas-liquid-solid interface of the concrete specimens and the microstructure of the concrete was analysed and tested using a Q600 simultaneous thermal analyser， Rigaku ultima-V1 X-ray diffractometer， Tensor 27 Fourier transform infrared spectrometer （FTIR） and Auto Pore V 9600 mercury compression meter. A cyclical pattern of growth， development and shedding of biofilms can be found， starting at around 30 days， entering a rapid development phase after 60 days， maturing to a peak thickness of 2200 μm at 120 days and then starting to shed until the next growth cycle at 150 days， with a positive correlation between the number of microorganisms in the membrane and the thickness of the biofilm. The results of the macroscopic properties of the concrete showed that the electric flux of the concrete in the sterile group reached 793.1 C at 120 days， while the electric flux of the concrete in the bacterial group was only 173.4 C. At 180 days， the concrete in the sterile control group cracked with a crack width of 0.11 mm， while no cracks were produced in the concrete in the bacterial test group. The compressive strength of the bacterial concrete increased by 6.9% while that of the aseptic concrete decreased by 7.1%. The results of the microstructural tests on the concrete showed that the gypsum production and C-S-H gel loss of the concrete in the bacterial group were less than that of the aseptic concrete， and the porosity of the concrete in the bacterial group was 1.1935% lower than that of the aseptic concrete. It can be concluded that sulfur-oxidizing bacteria attached to the gas-liquid-solid interface of the concrete gradually form biofilms， with periodic changes in the thickness of the film and the number of microorganisms within it. Sulfur-oxidizing bacteria and their biofilm have a protective effect on the microstructure of the concrete. The negatively charged nature of the sulfur-oxidizing bacteria repels the migration of SO 4 2- from the medium to the concrete and the dense nature of the biofilm also leads to a reduction in the mass transfer efficiency of SO 4 2- ， thus slowing down the erosion of SO 4 2- into the concrete.

Effect of Bio-Mineralization on Concrete Performance: Carbonation, Microhardness, Gas Permeability and Cl- Migration

Coupled Effects of Carbonation and Bio-Deposition in Concrete Surface Treatment

Mechanism of Bacterial Control of Mineralisation Gradient at the Surface Layer of Cement-Based Materials

Microbial Interactions with Mineral Building Materials

Study on the Effects and Mechanism of the Reinforcement of Soft Clay Via Microbially Induced Carbonate Precipitation

Microbial Mineralization at the Surface Layer of Cement-Based Materials and Its Effect on Efflorescence Performance

Bio-mineralization on cement-based materials consuming CO2 from atmosphere

Carbonation-enhanced Interfacial Transition Zone in Biochar-Cement Mortar

Effect of Biochar Dosage and Fineness on the Mechanical Properties and Durability of Concrete

Effect of Sulfur-oxidizing Bacteria on Concrete Properties in Seawater Environment

Self-healing of Cracks in Cement-Based Materials Through Bio-Mineralization of Low Air-Dependency Microorganisms

Aerobic Bacteria Induced Biomineralization: Effects of Nutrient and Calcium Content on the Nanostructure and Chemical Composition of Simulated Cement Mixture

Modification of Carbonation-Cured Cement Mortar Using Biochar and Its Environmental Evaluation

Biomineralization Process of CaCO3 Precipitation Induced by Bacillus mucilaginous and Its Potential Application in Microbial Self-healing Concrete

The Effect of Self-Healing Microorganism-Encapsulating Concrete on Enhancing Concrete Compressive Strength

A new method for anti-efflorescence of mortar by bio-mineralization

Micro-macro investigation on bio-cemented sand under different grouting saturation: an effective enhancement method

Effect of Bacillus mucilaginosus on hydration and microstructure of hardened pastes of C3S at early age: Simulation and experiment

Effects of Pure Carbonation on Pore Structure and Water Permeability of White Cement Mortars

Bio-mineralization induced by <i>Bacillus mucilaginosus</i> in crack mouth and pore solution of cement-based materials

Biomineralization in Metakaolin Modified Cement Mortar to Improve Its Strength with Lowered Cement Content.