Abstract:Proton exchange membrane fuel cells (PEMFCs) possess the benefits of high conversion efficiency, low operation noise and no pollution which are considered as potential power solutions for the automotive application. The supply and recirculation of hydrogen determines the output performance of PEMFC that is required to be well regulated. The hydrogen excess ratio (HER) is asked to locate at appropriate operating points and the pressure difference between anode and cathode should be limited within a reasonable range. In this paper, a pseudoreference-based multiple-input multiple-output (MIMO) model predictive control (MPC) integrated with the feedback linearization is proposed for the HER regulation and the pressure balance of electrodes. The nonlinear hydrogen delivery system model is developed which consists of two actuators: flow control valve and hydrogen circulating pump. To address the high nonlinearity of the hydrogen delivery system, the feedback linearization is formulated. The MIMO MPC is then developed based on the feedback linearized model with the defined pseudoreference which can effectively reduce the overshoot of HER. Comparing with the normal MPC based on one working-point first-order Taylor expansion, the more accurate hydrogen regulation performance of the proposed MPC can be achieved. The proposed MPC can effectively reduce the HER overshoot by 59.25% at the initial response phase with nearly same convergence time. Under the New European Driving Cycle (NEDC) simulation condition, the average overshoot reduction of anode pressure and HER can reach to 47.45% and 77.34% that demonstrates a well application prospect of the proposed MPC in the automotive PEMFC hydrogen regulation. A hardware in loop (HIL) experiment was finally conducted to show the real-time capacity of the proposed MPC method.

Feedback Linearization-Based MIMO Model Predictive Control with Defined Pseudo-Reference for Hydrogen Regulation of Automotive Fuel Cells

Model-based Fuel Pressure Regulation Algorithm for a Hydrogen-Injected PEM Fuel Cell Engine

Modeling and Control of Air Stream and Hydrogen Flow with Recirculation in a PEM Fuel Cell System—ii. Linear and Adaptive Nonlinear Control

A Nonlinear Control Strategy for Fuel Delivery in PEM Fuel Cells Considering Nitrogen Permeation

Safe Deep Learning-Based Offset-Free MPC for Green Hydrogen Injected PEMFC Systems

Modeling and Optimal Control of Hydrogen Fuel Cell Cogeneration System

Robust Regulation of Oxygen Excess Ratio and Cathode Pressure for PEMFC Air Supply Systems with Centrifugal Compressor

Model Predictive Control of Bidirectional DC/DC Converters for Hydrogen Fuel Cell Vehicles

Adaptive Control of Oxygen Excess Ratio in a Proton Exchange Membrane Fuel Cell System

Segmented Model-Based Hydrogen Delivery Control for PEM Fuel Cells: a Port-Hamiltonian Approach

Numerical Simulation on Pressure Dynamic Response Characteristics of Hydrogen Systems for Fuel Cell Vehicles

Hierarchical Fuel-Cell Airpath Control: an Efficiency-Aware MIMO Control Approach Combined with a Novel Constraint-Enforcing Reference Governor

Feedback Linearization Based Air Pressure and Mass Flow Rate Regulation for PEMFCs

A Novel Adaptive Model Predictive Control for Proton Exchange Membrane Fuel Cell in DC Microgrids

Design and implementation of model predictive control for an open-cathode fuel cell thermal management system

Anti-disturbance control of oxygen feeding for vehicular fuel cell driven by feedback linearization model predictive control-based cascade scheme

Offset-Free Model Predictive Control of Fuel Cell DC–DC Boost Converter with Low-Complexity and High-Robustness

Control of fuel cell air supply system based on LPV model

Observer Based Fuel Delivery Control for PEM Fuel Cells with a Segmented Anode Model

A fuzzy logic PI control with feedforward compensation for hydrogen pressure in vehicular fuel cell system

Nonlinear MPC Controller Design for AIR Supply of PEM Fuel Cell Based Power Systems