Abstract:The super-twisting sliding mode control (ST-SMC) is widely used in fuel cell system control due to the simple control law and strong robustness. However, it requires an accurate system model. Generally, literature usually reduces the system order and directly gives the empirical value for the system and controller parameters or conducts coefficient identification of the fuel cell voltage model, lacking the specific identification method for system physical parameters and controller parameters. In this paper, a relatively complete control-oriented ninestate fuel cell system model was established, including the model of compressor flow using the artificial neural network method, and the improved voltage model. Then, the data-driven method for key parameter identification was proposed, including the fuel cell throttle factor and motor voltage changing rate considering time delay. In addition, the parameter tuning method for controller design was proposed as well. These two methods are of originality. After the model validation in the perspective of steady and transient performance, the comparison was carried out between the ST-SMC and PID controller. It is found that the throttle factor of the cathodic fuel cell inlet and the delay effect in terms of changing rate of motor voltage impact the system model, where the throttle factor is time-variant, and the delay is noticeable which differs with the step magnitude of the motor voltage. The parameter tuning and boundary estimation of ST-SMC are very specific, owing to the process of treating flow rate as a state, not speed, and are convenient to be generalized. The better ability in anti-flooding exhibits the importance of parameter identification. Although the study is conducted in a low-pressure system, the method proposed in this paper is universal and could be applied to other fuel cell controls for better system efficiency and reliability.

Modeling and Optimal Control of Hydrogen Fuel Cell Cogeneration System

An Improved Fuzzy PID Control Method Considering Hydrogen Fuel Cell Voltage-Output Characteristics for a Hydrogen Vehicle Power System

Distributed Optimal Scheduling of Multi-Microgrid System with Hydrogen Based on Model Predictive Control

Modeling and Control of Air Stream and Hydrogen Flow with Recirculation in a PEM Fuel Cell System—i. Control-oriented Modeling

A Modified MPC-Based Optimal Strategy of Power Management for Fuel Cell Hybrid Vehicles

Model Predictive Control of Bidirectional DC/DC Converters for Hydrogen Fuel Cell Vehicles

Hydrogen Value Chain and Fuel Cells Within Hybrid Renewable Energy Systems: Advanced Operation and Control Strategies

Modeling And Simulation Of A Modern Pem Fuel Cell System

Numerical Simulation on Pressure Dynamic Response Characteristics of Hydrogen Systems for Fuel Cell Vehicles

Optimal Control of a Hydrogen Microgrid Based on an Experiment Validated P2HH Model

Method for System Parameter Identification and Controller Parameter Tuning for Super-Twisting Sliding Mode Control in Proton Exchange Membrane Fuel Cell System

A critical survey of proton exchange membrane fuel cell system control: Summaries, advances, and perspectives

Control of fuel cell air supply system based on LPV model

Model Predictive Control of an Integrated Energy Microgrid Combining Power to Heat and Hydrogen

A Control Method Based on Optimal Flow Rate for Fuel Cell Cogeneration Waste Heat Utilization System with Auxiliary Heat Transfer Loop

A Novel Adaptive Model Predictive Control for Proton Exchange Membrane Fuel Cell in DC Microgrids

An energy management strategy for fuel cell hybrid electric vehicle based on a real-time model predictive control and pontryagin's maximum principle

Multi-Objective Parameter Configuration Optimization of Hydrogen Fuel Cell Hybrid Power System for Locomotives

Design and implementation of model predictive control for an open-cathode fuel cell thermal management system

Modeling and control for PEM fuel cell stack system

Multiobjective Optimal Predictive Energy Management for Fuel Cell/Battery Hybrid Construction Vehicles