Abstract:Despite ceaseless efforts in past decades, the memory effect of semi-crystalline polymers has not been elucidated completely yet. An important reason why is that residual lamellar crystals in the structured melt are difficult to characterize. Recently, we developed a new small-angle X-ray scattering (SAXS) theory [Li et al. (2019). IUCrJ, 6, 968–983] and Fourier transform method [Li et al. (2020). CrystEngComm, 22, 3042–3058] for lamellar crystals that could derive structural information from SAXS readily. In this study, we tried to employ the new theory and method to characterize residual lamellar crystals in the structured melt. It was found that although scattering peaks cannot be observed in raw scattering profiles, they actually exist. Subtracting free-melt scattering and multiplying by q4 benefit the observation of these weak scattering peaks. With the new Fourier transform method, it was found that indeed as proposed previously, thicker lamellar crystals exist in the structured melt. To determine the lateral size of residual lamellar crystal especially, a new method was developed under the guidance of the new theory. With the new method, it was found that although the crystallinity is very low (∼1% at 174°C), the lateral sizes in the structured melts are still large, e.g. 45.3 nm at 174°C, much greater than the critical nucleation size. This implies that these residual lamellar crystals can act as athermal nuclei after quenching to a lower temperature, as proposed by Ziabicki & Alfonso [(1994). Colloid Polym. Sci. 272, 1027–1042; (2002). Macromol. Symp. 185, 211–231] more than 20 years ago. The methodologies proposed here could also be applied to other polymer lamellar systems.

Back Cover: Macromol. Rapid Commun. 14/2005

Crystallization kinetics and crystalline structure of biodegradable Poly(ethylene adipate)

Surface Fixing Effect of Vacuum Evaporated Particles on Polyethylene Single Crystals

Influence of Surface Morphology and Microstructure on Performance of CVD Tungsten Coating under Fusion Transient Thermal Loads

Surface Spin Pinning Effect of Polymer Decomposition Residues in CoCr2O4 Nanocrystallites System

Electron Microscopy and Diffraction of Crystalline Dendrimers and Macrocycles

Effects of Heat Treatment on Structure Transformation of Cr/Al Composite Coatings

Effects Of Wc Crystal Characteristics On Microstructure And Mechanical Property Of Hvof-Sprayed Wc-Cocr Coatings

The Effect Of Co-60 Gamma-Rays On The Crystal Structure, Melting And Crystallization Behavior Of Poly(Butylene Succinate)

Mechanistic Investigation of the Interface Crystallization Behavior of Amorphous-Co Bonding Phase under Thermal Conditions and Its Impact on Cohesive Strength Via New Phase Precipitation

Effect of Supercritical Carbon Dioxide on the Crystallization Behavior of Poly(ether Ether Ketone)

Macromol. Chem. Phys. 5/2007

The Effect of a Coating on the Crystallization of Multicomponent Co-Based Amorphous Alloys

Surface Crystal Nucleation and Growth in Poly (ε-caprolactone): Atomic Force Microscopy Combined with Fast Scanning Chip Calorimetry

Microstructure characterization of advanced protective Cr/CrN+a-C:H/a-C:H:Cr multilayer coatings on carbon fibre composite (CFC)

Effect of Coating Pre-Treatment on Surface Recrystallization of DD6 Single Crystal

Investigation of Crystallization of PVCH‐PE‐PVCH Triblock Copolymer in Supercritical Carbon Dioxide

Crystal Structure and Its Transition for Poly(Aryl Ether Ketone Ketone)S .1.

Detection and Characterization of Folded-Chain Clusters in the Structured Melt of Isotactic Polypropyl-Ene.

Laser-irradiation-induced dynamically recrystallized microstructure and properties of supersonic-particle-deposited Ni-Fe-Cr-Nb-Ti-Al high-entropy alloy coating

Microstructure evolution and adhesion properties of thick Cr coatings under different thermal shock temperatures