Abstract:Wake vortex evolution of a square cylinder with a slot synthetic jet issuing from the cylinder’s rear surface has been experimentally investigated using the time-resolved particle image velocimetry technique. The Reynolds number based on the side length of the square cylinder is $Re=836$. The excitation frequency normalized by the natural shedding frequency $f_{e}/f_{0}$ varies from 0 to 6 at the dimensionless stroke length $L_{0}/w=72.6$. The distributions of the time-averaged Reynolds stresses present significant differences as the excitation frequency increases. With control, the mean streamwise velocity deficit of the wake recovers more quickly in comparison with the natural case, and the vertical velocity fluctuation intensity becomes weaker. Moreover, a drag reduction can be achieved for the control cases, especially, for $f_{e}/f_{0}=4$ and $f_{e}/f_{0}=6$, a thrust instead of drag reduction can be obtained. The profiles of the mean streamwise velocity tend to have jet-like distributions. The wake vortex dynamics and its evolution with the excitation frequency are revealed. (i) For the low excitation frequency cases ($f_{e}/f_{0}=0.5$, 1, 2), no significant changes in the dominant frequency and the spanwise vortex structures are observed in comparison with the natural case. (ii) For the moderate excitation frequency case ($f_{e}/f_{0}=3$), the wake vortex shedding frequency is locked on half of the control frequency. In this case, the shear layer is divided into two parts by the synthetic jet vortex, and the wake vortices with smaller scales still shed asymmetrically and appear closer to the square cylinder. (iii) For the high excitation frequency case ($f_{e}/f_{0}=6$), the flow is governed by the synthetic jet. As a result of strong perturbations of the synthetic jet, the wake vortex shedding becomes symmetric with the shedding frequency consistent with the control frequency. And the separation is suppressed effectively. The different control effects of the slot synthetic jet on a square cylinder and a circular cylinder are also compared in detail. Generally speaking, the circular cylinder is easier to be controlled due to its non-fixed separation points.

Active Flow Control of the Dynamic Wake Behind a Square Cylinder Using Combined Jets at the Front and Rear Stagnation Points

Wake Vortex Evolution of Square Cylinder with A Slot Synthetic Jet Positioned at the Rear Surface

Wake Flow Control of a Square Cylinder Via Distributed Jets over the Rear Porous Surface

Dynamic Wake of a Square Cylinder Controlled with Steady Jet Positioned at the Rear Stagnation Point

Active Wake Control of Flow Past a Circular Cylinder with Slot Jet

Dynamics of the forced wake of a square cylinder with embedded flapping jets

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

Cylinder Wake Flow in Confined Channel and Its Active Control by Sweeping Jets

Fluid Dynamics Behind a Circular Cylinder Embedded with an Active Flapping Jet Actuator

Wake-vortex Evolution Behind a Fixed Circular Cylinder with Symmetric Jets

Effects of Distributed Suction Through the Porous Side-Walls of a Square Cylinder on Separation and Wake Flows

Passive Jet Approach to Control the Flow over a Circular Cylinder

Suppression of Unsteady Vortex Shedding from a Circular Cylinder by Using a Passive Jet Flow Control Method

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Wake stabilization behind a cylinder by secondary flow over the leeward surface

Effects of steady wake-jets on subcritical cylinder flow

Wake Control of a Bluff-Body Via Distributed Jets over Its Surface

Square cylinder flow controlled by a synthetic jet at one leading edge

Large Eddy Simulation of Passive Jet Flow Control on the Wake of Flow Around a Circular Cylinder

Numerical study on passive-jet flow control for chamfered square cylinder

Primary instability, sensitivity and active control of flow past two tandem circular cylinders