Modification of graphene photodetector by TiO 2 prepared by oxygen plasma

Yawei Liu,Beiyun Liu,Yi Wu,Xiaoqing Chen,Aibing Chen,Feihong Chu,Shubo Feng,Chen Zhao,Hongwen Yu

DOI: https://doi.org/10.1007/S10853-021-05971-6

IF: 4.5

2021-01-01

Journal of Materials Science

Abstract:Single-layer graphene has been proved to be an ideal material for broadband high-speed photodetector. However, the pure graphene photodetector photoresponsivity is limited to tens of mA/W by the low optical absorption and short exciton life of graphene. When higher responsivity is needed, the graphene layer needs to be coupled with other materials, e.g., Titanium Dioxide (TiO 2 ). Conventional TiO 2 recipes require either solution or high temperature which tends to destruct the graphene layer. In this work, TiO 2 is synthesized by oxygen plasma treating Ti film. This novel synthesis route of TiO 2 avoids defects introduced by the conventional recipes. The hybrid device shows a high photoresponsivity of ~ 179 A/W, a fast response time of ~ 20 ms and a specific detectivity of ~ 9.12 × 10 9 Jones with the incident light intensity of sub-microwatt. Under the illumination, the photon absorption in graphene creates electron–hole pairs, which were separated at TiO 2 /graphene interface by an internal electric field and corresponding electrons transfer from the graphene to TiO 2 layer. The high photoresponsivity is attributed to the long lifetime of the photoexcited charge carriers caused by a built-in field at the interface of TiO 2 /graphene. Our research provides an effective method to improve the photoresponse of the graphene-based photodetector. In addition, our TiO 2 recipe could be applied in the fabrication of other electronic devices where solution or high temperature processes are difficult.