Combustion Stability, Burnout and NOx Emissions of the 300-MW Down-Fired Boiler with Bituminous Coal: Load Variation and Low-Load Comparison with Anthracite

Xin Zhang,Zhichao Chen,Mingdi Zhang,Lingyan Zeng,Zhengqi Li

DOI: https://doi.org/10.1016/j.fuel.2021.120641

IF: 7.4

2021-01-01

Fuel

Abstract:The new energy generating capacity is increasing year by year in the electric industry structure, but it is greatly influenced by the natural conditions. Coal-fired power generation unit boilers connected to the grid have the ability of flexible peak-load regulation and long-term low-load operation is required. However, the combustion stability is weak under the low-load when the coal-fired boiler burning anthracite. Down-fired boiler fueled with bituminous coal gradually attract the attention. Ignition and combustion stability, burnout, and NOx emissions are experimentally studied under the various loads on a 300 MW down-fired boiler fueled with bituminous coal, and the results compared with anthracite under the low-load. The ignition distance of the coal/air flow burning bituminous coal is gradually advanced with the reduction of load. And under the corresponding load, the ignition heat of the coal/air flow when burning bituminous coal is more than 37% lower than that burning anthracite. With the reduction of load, the decreasing rate of the overall furnace temperature and the cross-sectional heat load in the primary combustion zone decreases, and the furnace temperature in the primary combustion zone is high under the low-load when bituminous coal is burned. Short ignition distance, low ignition heat and high furnace temperature ensures the strong combustion stability of burning bituminous coal under the low-load. Moreover, under three various loads with burning bituminous coal, the carbon in the fly ash are all less than 1.1%, and the NOx emissions at the furnace exit are 410, 397 and 288 mg/m(3) @ 6% O-2, respectively.