Abstract:Low compression end temperatures, high heat loss, and large resistance torque cause difficulty in starting con-ventional diesel engines at extremely low temperatures. The diesel-electric hybrid is equipped with high-capacity battery, which can support high-energy-consuming preheating measures to improve low-temperature cold-start performance. However, only a few studies have been conducted on the effect of preheating on the low-temperature cold-start performance of diesel-electric hybrid. In this study, the influence of different preheat-ing temperatures on the performance, emissions, energy consumption, and conversion of a diesel-electric hybrid was experimentally investigated by designing an environmental simulation system and a preheating system. The results showed that intake air preheating consumed less energy and maintained a high energy conversion effi-ciency. As the intake air temperature increased, the combustion conditions improved, increasing the indicated mean effective pressure and enhancing combustion stability. However, intake preheating was invalid when the ambient temperature was below 244 K because of the high heat loss and large resistance torque. As the coolant temperature increased, the ignition delay period was significantly reduced, allowing the maximum pressure in the cylinder to increase. The corresponding position became closer to the top dead center, resulting in a steady increase in the speed rise rate, a reduction in hydrocarbon emissions from 1403 ppm to 298 ppm, and a reduction in opacity from 85% to 43%. The increase in the lubrication temperature mainly decreased the resistance torque, resulting in a reduction in the drag time and rise time of 0.37 s and 2.21 s, respectively. At 233 K, the minimum energy consumption of the combined preheating of the coolant and intake air was 2557 kJ. In contrast, the combined preheating of the lubricant and intake air was only 379 kJ, but the emission performance of coolant preheating was better than that of lubricant preheating. This result could be considered as the constraint boundary for optimizing the total equivalent energy consumption and is useful for optimizing the preheating strategy and development of diesel-electric-hybrid low-temperature thermal management.

Environment-adaptive Method to Control Intake Preheating for Diesel Engines at Cold-Start Conditions

An Assessment of the Application of Catalyst Preheating Prior to Engine Cold Start to Improve the Filtration Performance of CDPF on Particulate Emissions

Effects of Cold Start Control Strategy on Cold Start Performance of the Diesel Engine Based on a Comprehensive Preheat Diesel Engine Model

Experimental Investigation of the Effects of Preheating Temperature on Low-Temperature Cold Start Performance, Emissions and Energy Conversion of Diesel-Electric Hybrid

Effects of Intake Preheating on Diesel Engine Power Performance during Starting Process

Reducing Cold Start Emissions from Automotive Diesel Engine at Cold Ambient Temperatures

Optimization of Cold Start Performance of Diesel Engine Under Low Temperature and High Altitude Environment

Environmental Adaptability Method for Improving the Cold Start Performance of the Diesel Engine Based on Pilot Injection Strategy

Impacts of different ambient temperatures on cold-start characteristics of speed-up duration of an ISAD hybrid diesel engine in plateau

Effect of Inlet Air Heating on Start Characteristics of A Common-Rail Diesel Engine in High Altitude Environment

An Experimental Study on the Measures for Improving Cold Start/Warm-up Process of Engine

Improving Cold Start and Transient Performance of Automotive Diesel Engine at Low Ambient Temperatures

Study on Power Performance of Engine Based on Diesel Preheat

Experimental Study on Improving the Cold Starting Ability of Diesel Engine

Experimental Study On The Thermal Management And Active Control Of Diesel Engine Exhaust Products Based On Energy Saving And Environmental Protection Requirements

Intake Air Heating Strategy to Reduce Cold-Start Emissions from Diesel Engines

Improvements on the start performance of diesel engine by fuel control strategy optimization and heating measures

Cold Start Performance of Diesel Engine at Extremely Low Ambient Temperatures and High Altitudes: the Superiority of Premixing Diethyl Ether

Effect of Altitude on In-Cylinder Heat Transfer of a Heavy Duty Diesel Engine

The Optical Investigation on Initial Flame Developing Characteristics of Diesel Jet under Cold Start Conditions

Experimental Study on Improving Cold Start Performance of Diesel Engines at Extremely Low Ambient Temperatures with Diethyl Ether