Abstract:The KOMAC has mainly used commercial oscilloscopes for beam current monitoring (BCM). The beam current is measured with an oscilloscope and the measured signal values are collected using Ethernet. At this process, Experimental Physics and Industrial Control System (EPICS) converts the raw voltage values into beam current and transmits each data to users via Channel Access (CA). The beam waveform is remotely shared by utilizing virtual network computing (VNC) to access the oscilloscope's graphic desktop. The process variables (PV) of beam currents can be monitored and stored simultaneously, and data analysis is possible at any time using an API. However, as the accelerator duty cycle improves, synchronization becomes necessary for beam data collection, and it has been confirmed that there are occurrences of missing the PV of the beam current. This issue has two main causes. Firstly, data collection operates in a polling method within TCP/IP communication. The advantage of polling is that its implementation is relatively straightforward. Since the client periodically sends requests, the communication system can predict when data will be received, reducing overhead. On the other side, a drawback is that no updates occur until data are requested, resulting in lower real-time capability. Therefore, without synchronization with the timing system, accurate collection of pulsed beam data becomes challenging. Secondly, as the beam duty increases, a considerable amount of beam data is missing due to transmission limits. To address this, a Data Acquisition (DAQ) for beam current acquisition has been developed, and testing and debugging have been completed. This paper describes the design, debugging, and operational plans of beam current monitoring system.

Prototype of a multi-host type DAQ front-end system for RI-beam experiments

A versatile DAQ, monitoring and data processing system for nuclear experiments in CAMAC and VME standards

A multi-channel DAQ system based on FPGA for long-distance transmission in nuclear physics experiments

An Updated Data Acquisition and Analysis System at RIBLL

Scalable DAQ system operating the CHIPS-5 neutrino detector

Development of next generation LLRF control system for J-PARC rapid cycling synchrotron

Development and integration of DAQ system for beam current monitoring of the KOMAC linac and beamlines

Development of a modular and scalable data acquisition system for calorimeters at a linear collider

A Multi-Parameter Data Acquisition System for the Collision Research Platform at Shanghai Ebit

A Flexible Data Acquisition System Architecture for the Nab Experiment

Digital Signal Acquisition System for Complex Nuclear Reaction Experiments

The MUonE DAQ: online track-finding and event selection in hardware at 40 MHz

A PXI-based Multi-channel Data Acquisition System for Fast Transient Pulses

Design and Implementation of High Performance DAQ System for IRFPA Testing

Online data acquisition and the control system for the Double Chooz experiment

Setup of Small Type DAQ System Based on VME Bus and FADC Module

Development of an ADC radiation tolerance characterization system for the upgrade of the ATLAS LAr calorimeter

RFSoC-based front-end electronics for pulse detection

A Multi-Channel Distributed DAQ for N-Tpc

The Prototype Design of Integrated Base for PMT with Pulse Digitalization and Readout Electronics

PCI/iRMX-based front-end data acquisition for the HT-7U experiment