Abstract:Background: The present study is designed as a proof-of-concept study to evaluate light/chemical hardening technology and a newly formulated polymethylmethacrylate, polyhydroxyethylmethacrylate, and calcium hydroxide (PPCH) plus polyanhydride (PA) (PPCH-PA) composite graft material as a bone substitute compared to positive and negative controls in a minipig model. Methods: PPCH-PA (composite graft); PPCH alone (positive control), PA alone (positive control), and no graft (negative control) were compared. Four mandibular premolar teeth per quadrant were extracted; a total of 48 implants were placed into sockets in three minipigs. Abutments were placed protruding into the oral cavity 4 mm in height for immediate loading. Crestal areas and intrabony spaces were filled with PPCH-PA, PPCH, or PA using a three-phase delivery system in which all graft materials were hardened by a light cure. In the negative control group, implant sites were left untreated. At 12 weeks, block sections containing implants were obtained. Evaluations included periodontal probing, pullout-force load, and stability measurements to determine implant stability, radiographs to examine bone levels, and scanning electron microscopy (SEM)-energy-dispersed spectroscopy to determine bone-to-implant contact. Results: Probing measurements did not reveal any pathologic pocket formation or bone loss. Radiographs revealed that immediate implant placement and loading resulted in bone at or slightly apical to the first thread of the implant in all groups at 12 weeks. Stability test values showed a relative clinical stability for all implants (range: -7 to +1); however, implants augmented with PPCH-PA exhibited a statistically significantly greater stability compared to all other groups (P <0.05). The newly formed bone in PPCH-PA-treated sites was well organized with less marrow spaces and well-distributed osteocytes. SEM revealed a tighter implant-socket interface in the PPCH-PA group compared to other groups with reduced microfissures and implant-bone interface fractures during pullout testing, whereas implants treated with PA or no graft showed ≈ 10-μm microfissures between the implant and bone with fractures of the intrathread bone. Conclusions: The newly formulated chemically hardened graft material PPCH-PA was useful in immediate implant placement after tooth extraction and resulted in greater stability and a well-organized implant-bone interface with immediate loading, especially in those areas where cancellous bone was present. The results of this proof-of-concept study warranted further research investigating different healing times and longer durations.

Hard tissue formation in pulpotomized primary teeth in dogs with nanomaterials MCM-48 and MCM-48/hydroxyapatite: an in vivo animal study

Preparation and Histological Study of Multi-Walled Carbon Nanotubes Bone Graft in Management of Class II Furcation Defects in Dogs

Histological evaluation of ProRoot mineral trioxide aggregate and Cold ceramic as root-end filling materials in animal models

An animal study on the effectiveness of platelet-rich plasma as a direct pulp capping agent

Pulpal responses following direct pulp capping of healthy dog teeth with dentine adhesive systems

Regenerative potential of mesoporous silica nanoparticles scaffold on dental pulp and root maturation in immature dog's teeth: a histologic and radiographic study

[Experimental Study on the Reconstruction of Mandibular Defects with a New Bioactive Artificial Bone Nano-Hydroxyapatite/polyamide-66 in Dogs].

Biocompatibility of mineral trioxide aggregate and biodentine as root-end filling materials: an in vivo study

One-year Radiographic and Clinical Performance of Bioactive Materials in Primary Molar Pulpotomy: A Randomized Controlled Trial

Radiological evaluations of low cost wollastonite nano-ceramics graft doped with iron oxide in the treatment of induced defects in canine mandible

Effectiveness of Three Agents in Pulpotomy Treatment of Permanent Molars with Incomplete Root Development: A Randomized Controlled Trial

Comparing effectiveness of mineral trioxide aggregate, bioceramic putty and tannic acid in maintaining pulp vitality after experimental pulpotomy in rats

Preliminary Evaluation of Platelet Rich Fibrin-Mediated Tissue Repair in Immature Canine Pulpless Teeth.

The use of light/chemically hardened polymethylmethacrylate, polyhydroxyethylmethacrylate, and calcium hydroxide graft material in combination with polyanhydride around implants in minipigs: part I: immediate stability and function

Application of the Magnesium Rod and Porous Mineralized Collagen Plug in Site Preservation in Dogs

Evaluation of Ti/Al alloy coated with biogenic hydroxyapatite as an implant device in dogs' femur bones

Using Mineral Trioxide Aggregate as a Pulp-Capping Material

The Effects of Tricalcium-Silicate-Nanoparticle-Containing Cement: In Vitro and In Vivo Studies

Evaluation of hyaluronic acid gel with or without acellular dermal matrix allograft in the treatment of class II furcation defects in dogs: A histologic and histomorphometric study

Effect of an oily calcium hydroxide suspension (Osteoinductal) on healing of intrabony periodontal defects. A pilot study in dogs

Porous Chitosan Bilayer Membrane Containing Tgf-Beta(1) Loaded Microspheres For Pulp Capping And Reparative Dentin Formation In A Dog Model