One-pot Hydrogenolysis of Cellulose to Bioethanol over Pd-Cu-WOx/SiO2 Catalysts

Dawang Chu,Zhicheng Luo,Yingying Xin,Chengzhen Jiang,Shaofeng Gao,Zhihao Wang,Chen Zhao

DOI: https://doi.org/10.1016/j.fuel.2021.120311

IF: 7.4

2021-01-01

Fuel

Abstract:The chemo-catalytic production of ethanol from nonedible lignocellulosic biomass is essential for mitigating energy shortage. In this work, we developed a multifunctional Pd-Cu-WOx/SiO2 catalyst for the one-pot aqueous-phase conversion of cornstalk-derived cellulose to ethanol with a yield of 42.5C% at 300 degrees C and 4 MPa H-2. Kinetic studies demonstrated that the transformation of cellulose to ethanol followed a number of consecutive steps namely, cellulose hydrolysis to glucose with H+ in hot water (k(1)), glucose conversion to glycolaldehyde over W species (k(2)), glycolaldehyde hydrogenation to ethylene glycerol (EG) over Pd (k(3)), and EG hydrogenolysis to ethanol over Cu (k(4), rate-determining step). The individual rates were well balanced on Pd, Cu, and WOx species to achieve an ethanol formation rate of 0.163 g.g(Cat).(-1)h(-1). The addition of Au to Cu-WOx species led to a relatively low k(3) and thus the formation of a substantial amount of humins, while the Ru introduction catalyzed the over-hydrogenolysis of ethanol to methane and ethane with a high rate, thereby lowering the selectivity to ethanol. The characterization results showed that both the electronic properties of Cu+ species and the Cu+/Cu-0 ratio on the Pd-Cu-WOx/SiO2 catalyst contributed to a specific C-O bond cleavage, especially for EG hydrogenolysis to ethanol during the cellulose conversion.