Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Periodic Narrow-Band Noise Denoising of Partial Discharge Signal Through Time-Frequency Analysis

Partial Discharge Signal Denoising Method Based On Frequency Spectrum Clustering And Local Mean Decomposition

Noise Suppression and Pulse Extraction Method Based on Fluctuation Characteristics of Partial Discharge Signals

Analysis and Rejection of Noises from Partial Discharge (PD) On-Site Testing Environment

Novel Denoizing Method for Partial Discharge Signals Using Singular Value Decomposition and Spectral Subtraction

An Automatic Tool for Partial Discharge De-Noising via Short-Time Fourier Transform and Matrix Factorization

Partial Discharge Signal Denoising Based on Singular Value Decomposition and Empirical Wavelet Transform

Detection and Identification Technologies of Wide Band Partial Discharge

A Denoising Method Based on Spectrum Clustering and Improved Empirical Wavelet Transform for Cable Partial Discharge

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Research on Partial Discharge Signal Detection Based on UHF Sensor Array and Eigenvalue Behavior Analysis

Method for PD Signal Self-denoising Based on Sensor Threshold

Noise Reduction of Partial Discharge in Power Cable Insulation Based on Deep Learning

Suppression of UHF partial discharge signals buried in white-noise interference based on block thresholding spatial correlation combinative de-noising method

A New Suppression Method for Narrow-Band Interference in Partial Discharge Signals With Chaotic Oscillator

A New Technique For Extracting Partial Discharge Signals In On-Line Monitoring With Wavelet Analysis

Measurement and analysis for pulse sequence of partial discharge signals under DC voltage

Suppression of the Periodic Narrow-band Noise with Mixed Frequencies in Partial Discharge On-line Monitoring

Extraction of Partial Discharges from Noises by Use of Wavelet and Pulse-Sequence Analysis

An Improved Denoising Method for Partial Discharge Signals Contaminated by White Noise Based on Adaptive Short-Time Singular Value Decomposition

Study on a Spatially Selective Noise Filtration Technique for Suppressing Noises in Partial Discharge On-Line Monitoring