Abstract:Belt grinding is commonly applied for precision manufacturing of difficult-to-machine materials like GH4169, owing to its satisfactory elastic grinding properties, high efficiency, and strong adaptability. Abrasive belt wear is a common occurrence during the grinding process; however, its mechanism and effect on machining quality, particularly its influence on residual stress (RS), remain unclear. In order to compensate for these shortcomings, by means of experimentation, this paper studies how the RS distribution of GH4169 plate is affected by abrasive belt wear during robotic belt grinding, and the influence mechanism is analyzed from the perspectives of grinding force and heat. Firstly, the whole life cycle of the abrasive belt is determined through a wear test, then a novel evaluating index based on relative material removal rate is proposed to quantitatively characterize the wear conditions of belt. Secondly, according to the new division criteria, abrasive belts at various wear stages are created, and then, comparative grinding experiments of the GH4169 plate are carried out. Finally, based on the experimentally measured data, this paper fully analyzes and discusses the surface and subsurface RS distribution differences of grinding traces. The experimental findings suggest that the effect of abrasive belt wear on the surface RS distribution is notable in the grinding direction, but not in the vertical direction of the grinding traces. Additionally, as the belt conditions deteriorate, the overall grinding force ratio decreases while the accumulation of grinding heat increases, which leads to the generation of surface residual tensile stress (RTS) in the grinding direction. Furthermore, as a result of the uneven heat diffusion, the surface RS along the vertical direction of the grinding traces is distributed in an approximately symmetrical manner, with higher RS values in the center and lower values on the sides. As for the subsurface RS distribution, on the whole, with the progression of belt wear, the values of the subsurface residual compressive stress (RCS) layer decrease.

A study of dynamic energy partition in belt grinding based on grinding effects and temperature dependent mechanical properties

Research on the Analytical Thermal Model in Surface Grinding by Cup Wheel

Validation of an analytical model for grinding temperatures in surface grinding by cup wheel with numerical and experimental results

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Experimental study on energy partition of polishing aero-engine blades with abrasive cloth wheel

Temperature field model in surface grinding: A comparative assessment

Energy Modeling for Variable Material Removal Rate Machining Process: an End Face Turning Case

Analysis of grinding mechanics and improved grinding force model based on randomized grain geometric characteristics

Establishment of dynamic grinding force model for ultrasonic-assisted single abrasive high-speed grinding

Introducing abrasive wear into undeformed chip thickness modeling with improved grain kinematics in belt grinding

Comprehensive investigation into the effects of relative grinding direction on abrasive belt grinding process

An analytical force and energy model for ductile-brittle transition in ultra-precision grinding of brittle materials

Modeling and Simulation of Temperature Field in High-Shear and Low-Pressure Grinding with Liquid-Body-armor-like Grinding Wheel

Modelling and analysis of the effect of nonlinear time-varying contact deformation on flexible precision grinding process

A simulation platform for optimal selection of robotic belt grinding system parameters

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

Heat flux distribution model and transient temperature field analysis in grinding of helical raceway

Analysis of abrasive belt wear effect on residual stress distribution in robotic belt grinding of GH4169

Experimental and numerical characterization of abrasive belt wear and debris formation during dry grinding of nickel-based superalloys with diamond abrasive belts

A Coupled Thermomechanical Modeling Method For Predicting Grinding Residual Stress Based On Randomly Distributed Abrasive Grains

The influence of wear volume on surface quality in grinding process based on wear prediction model