Abstract:The porous wick, as a core component of the loop heat pipe (LHP), serves as a source of circulation power. Inspired by the transport system of plant vessels, a radially stacked polyethersulfone (PES) porous wick was designed using PES membranes with an anisotropic porous structure. The PES membranes exhibited excellent capillary force and high permeability. However, the supply capacity of the axially stacked wick was far inferior to that of sintered wick due to the problem of contact gaps and pore misalignment between layers. From the bionic point of view, a laminar winding special transport structure, which is perpendicular to the direction of liquid transport was proposed. The method effectively avoids the adverse effects of gap and pore misalignment on liquid transport. Combining experimental and simulation methods, the heat transfer characteristics and liquid transport characteristics of the radial stacking polyethersulfone wick (RPES) were studied and compared with those of traditional axial stacking polyethersulfone wick (APES) and sintered nickel wick. The results showed that the heat transfer performance of RPES-LHP was significantly improved, with the heating surface temperature maintained at 54.1 °C and thermal resistance of 0.095 °C/W under a heat load of 400 W, which was respectively 26.6 °C and 0.066 °C/W lower than that of the APES-LHP. The evaporator thermal resistance of RPES-LHP also ranked among the top in existing research on wicks. Simulation results indicated that the radial stacking method avoided capillary force weakening and flow resistance increase caused by gap and pore misalignment, thereby enhancing the supply capacity of RPES. The concept of regulating the stacking orientation of the wick to be perpendicular to the direction of liquid transport can strengthen the supply capacity and provide light on the design of porous wicks in the future.

Optimizing L-shaped Heat Pipes with Partially-Hybrid Mesh-Groove Wicking Structures

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Thermohydraulic Performance Optimization of Integrated Porous Pin Fins in Microchannel Heat Sink Using Shape Optimization Coupled with NSGA

Enhanced capillary pumping performance of flexible heat pipe device with multi cross-section ultra-thin wick

Biomimetic porous wick with efficient fluid transport and excellent heat transfer for loop heat pipes

Methods for performance optimization of ultra-thin heat pipes with composited wick

Effect of evaporation and condensation section length ratio on thermal performance of aluminum flat plate heat pipe with different micro grooved wicks

Analysis of thermal characteristics of the heat pipes with segmented composite wicks

An Experimental Study of a Composite Wick Structure for Ultra-Thin Flattened Heat Pipes

Investigation on Microheat Pipe Array with Arteries

Experimental study on the thermal performance of ultra-thin flat heat pipes with novel multiscale striped composite wick structures

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Thermal performance enhancement of an ultra-thin flattened heat pipe with multiple wick structure

Experimental study on thermal performance of ultra-thin heat pipe with a novel composite wick structure

Biomimetic Copper Forest Wick Enables High Thermal Conductivity Ultrathin Heat Pipe

Experimental research on the thermal performance of a flat evaporator loop heat pipe with a new composite wick

Enhanced evaporation performance on a novel microstructured surface with vertical dimension gradient

Ultra-efficient Heat Pipes Enabled by Nickel-Graphene Nanocomposite Coatings: Concept and Fundamentals

Numerical Investigation on Internal Structures of Ultra-Thin Heat Pipes for PEM Fuel Cells Cooling

Three-dimensional oscillating heat pipes with novel structure for latent heat thermal energy storage application

Study of the heat transfer performance of gravity heat pipes based on lattice Boltzmann surface modification