Abstract:The BMD reference curve is the reference value used for diagnosing osteoporosis and assessing bone mass changes. Its accuracy would affect the correctness of T -score and Z -score values and thus the reliability of diagnostic results. In this paper, we report the use of a new method, a Cartesian coordinate numeration system, to establish BMD reference curves at different skeletal sites in women. In a reference population of 3,919 women ranging in age from 5–85 years, we used the dual X-ray absorptiometry (DXA) bone densitometer to measure BMD at the posteroanterior spine (PA; vertebrae L1–L4), followed by a paired PA/lateral spine scan of the vertebral bodies of L2–L4, expressed in g/cm 2 and g/cm 3 , and of the hip and forearm. We chose the cubic regression model to best fit BMD curves that varied with age at different skeletal sites. We then referred the BMD of the fitting curves established by the method of the coordinate numeration system as reference curves, compared them to BMD reference curves derived from the fitting curve equation or age cross-section, and calculated the deflection degrees of the BMD reference curves acquired from the fitting curve equation. At the PA spine, lateral spine (expressed in g/cm 3 ), femoral neck, Ward’s triangle and radius + ulna ultradistal, the reference curves calculated from the equation were significantly lower than those confirmed by the method of the coordinate numeration system; whereas, at the lateral spine (expressed in g/cm 2 ), total hip, and radius + ulna 1/3 sites, the reference curves derived from the equation were markedly higher than those acquired from the coordinate numeration system. The differences in the two kinds of reference curves calculated by these two different methods gradually increased along with the increment in ages of the women. At the peak value of the reference curves, the BMD calculated from the equation deflected from 2.02% to −10.0% from the BMD acquired from the coordinate numeration system at different skeletal sites, and from 21.5% to −121.8% until the age of 85 years. The highest positive deflection of 65.2% existed at the lateral spine (expressed in g/cm 2 ) and the lowest positive deflection of 21.5% at the total hip. The maximum negative deflection of −121.8% was at the radius + ulna ultradistal, and the minimum negative deflection of −32.6% at the PA spine. The BMD curve acquired from age cross-section was highly positive compared with the one derived from the coordinate numeration system ( r =0.955–0.985 p =0.000) with no significant difference between them. Various analysts used such a method to obtain the coefficient of variance (CV) in BMD precision on each curve that was from 0.05–0.19%. Our study shows that the Cartesian coordinate numeration system is an accurate, precise and reliable method and can serve to reveal the serious drawbacks of using the fitting curve equation to calculate BMD. The BMD reference curves established by this coordinate numeration system maintained the authenticity of the fitting curve, whereas, using the fitting curve equation to obtain BMD reference curves at different skeletal sites led to distortion, and resulted in false increases or decreases in T -score and Z -score values.

An Updated Reference For Calculating Bone Mineral Density T-Scores

Radiographic Predictors for Bone Mineral Loss CORTICAL THICKNESS AND INDEX OF THE DISTAL FEMUR

Association Between Plasma Total Homocysteine Level Within Normal Range and Bone Mineral Density in Adults

Trends in Bone Mineral Density in US 6-80 Years Old: Findings from 2005-2020 NHANES Surveys

A Comprehensive Analysis of Bone Mineral Density Changes across the Lifespan: Insights from National Surveys

Establishment of BMD reference curves at different skeletal sites in women, using a Cartesian coordinate numeration system

Establishing Age-Adjusted Trabecular Bone Score Curves Using Dual-Energy X-ray Absorptiometry in Chinese Women and Men: a Cross-Sectional Study

Trabecular Bone Score (TBS) Varies with Correction for Tissue Thickness Versus Body Mass Index: Implications when Using Pediatric Reference Norms

The role of hypertension in bone mineral density among males older than 50 years and postmenopausal females: evidence from the US National Health and Nutrition Examination Survey, 2005–2010

Age-related Bone Mineral Density, Bone Loss Rate, Prevalence of Osteoporosis and Reference Database of Women at Multiple Centers in China

[Comparison of Differences Between Hip and Lumbar Bone Mineral Density in Dual Energy X-ray Absorptiometric Data].

Studies on the Standards for the Bone Mineral Density Measurement at Forearm Skeletal Sites in the Diagnosis of Osteoporosis

Age and Gender Differences in Vertebral Bone Marrow Adipose Tissue and Bone Mineral Density, Based on MRI and Quantitative CT

Age at Attainment of Peak Bone Mineral Density and Its Associated Factors: the National Health and Nutrition Examination Survey 2005-2014.

Trends in osteoporosis and low bone mass in older US adults, 2005-2006 through 2013-2014

Effect of the Bone Density and Standard Deviation of the Young People to the Prevalence of Osteoporosis

Establisbment of Bone Mineral Density Reference Plots and Peaks for Different Skeletal Sites in Women

Bone Mineral Density Reference Standards for Chinese Children Aged 3-18: Cross-Sectional Results of the 2013-2015 China Child and Adolescent Cardiovascular Health (CCACH) Study

Age-related Changes of Serum Bone Alkaline Phosphatase and Cross-Linked C-telopeptides of Type I Collagen and the Relationship with Bone Mineral Density in Chinese Women

Contributions of Clinical and Technical Factors to Longitudinal Change in Trabecular Bone Score and Bone Density: A Registry‐Based Individual‐Level Analysis

Develop a bone mineral density T-score distribution nomograms based on osteoporosis risk factors for middle-aged and older adults