Abstract:The development of a bonded glass-steel element that is capable to i) transfer out-of-plane loads due to wind loads in transverse direction, ii) in-plane shear loads, due to wind in longitudinal direction and iii) in-plane compression due to self-weight implies that the structural continuous adhesive glass-metal connection becomes an integral part of the entire bonded glass-steel unit. The frame members are restrained by the joint-glass system due to the glass bonded to the steel frame. To assess the capability of continuous adhesive glass-steel connections to transfer the abovementioned loads, research is indispensable. The available knowledge on the capacity of glass panes used as structural bracing element in steel frames is limited. This paper reports about the structural performance of welded steel corners, both not bonded and bonded with glass panes, to assess the in-plane load-bearing capacity of these connections. In a first experimental phase tests on welded steel corners with different configurations are conducted, whilst during the second phase specimens bonded with glass panes on both sides are tested. Numerical models are developed and validated based on the experimental results, which are then used for parametric studies. As such, the rotational stiffness of semi-rigid welded steel corner configurations and the additional stiffness obtained by bonded glass panes can be determined. The results demonstrated that the specimens with adhesively bonded glass panes on both sides using the structural silicones Sikasil® SG-500 and DowSilTM 993, and the hybrid polymer adhesive Soudaseal 2 K, significantly increased the initial rotational stiffness of the welded steel corners. Specimens bonded with the hybrid polymer adhesive behave significantly stiffer than specimens bonded with the structural silicones. Parametric studies on validated finite element models reveal that the effect of the glass thickness is important for low values of the adhesive thickness . The width-to-thickness ratio of the adhesive layer largely influences the value of the rotational stiffness of the connection. The generated data by the numerical models can now be implemented in analytical models for the calculation of steel structures with semi-rigid joints.

Point-fixed connections in structural glass with injection mortar infill. experimental investigation and numerical simulations

Mechanical behaviour of connections for cold-formed steel-glass shear wall panels

Experimental Test on Loading Capability of Glass Panels with Overlapped Connectors

Investigation of the structural performance of continuous adhesive glass-metal connections using structural silicone and hybrid polymer adhesives

Load bearing and failure behaviour of adhesively bonded glass-metal joints in façade structures

Experimental Investigation into In-Plane Bearing Capability of Single-Layer Glass Panels with Overlapped Connectors

An Experimental Study on the Structural Behaviour of Laminated Glass Members under Combined Axial Compression and In-Plane Bending

Experimental Study of the Carrying Capacity of Point-Supported Glass Panels Subjected to Loads in the Panel Plane

Finite Element Study on Around-the-Hole Stresses of Point-Supported Insulating Glass Unites

Numerical simulation of anti-shatter films (ASF) for mechanical post-breakage analysis of retrofitted glass

Finite element analysis on point-supported parallelogram insulating glass unit

Post-Fracture Stiffness and Residual Capacity Assessment of Film-Retrofitted Monolithic Glass Elements by Frequency Change

A finite element model for impact simulation with laminated glass

Prediction of moisture diffusion and failure in glass/steel adhesive joints

Investigatio N into Short Term Behaviors of Embedded Laminated Glass Connections with Various Configurations

Role of secondary components in the numerical analysis and in-plane seismic performance assessment of glass curtain walls

Study on the Stress and Failure Strength Around the Hole in Point Supported Glass Panels

In-plane bending of laminated glass fin strengthened through external bonding

Structural Strength of Heat-Strengthened Glass

Mechanical Enhancement of Fractured Laminated Glass considering Fragment Overlaps and Temperatures

Viscoelastic Fractional Model with a Non-Uniform Time Discretization for Laminated Glass: Experimental Validation