Abstract:To optimize the configuration of spatial-temporal resources at intersections with mixed traffic flow of passenger cars and heavy vehicles, this paper proposes a set of mixed integer linear programming（MILP） model with aim to maximize the intersection capacity. In the model, different impacts of the locations of permitted lanes on flows of different modes and vehicle turning maneuvers are considered to increase the model applicability. The constrains on the relative setting position of permitted lanes for left-turn, through and right-turn are released. That’s to say, the permitted left-turn lanes don’t have to be on the left of the permitted through lanes, and the permitted through lanes don’t have to be on the left of the right-turn permitted lanes. This may induce some new flow conflicts（potential conflicts） and whether these conflicts exist is affected by the lane channelization scheme. Thus, some constraints are added in the model, among which one is to identify which potential conflicts are arisen with specific lane scheme, the other is to determine these conflicts’ impact on the configuration of temporal resources at intersections. The results from numerical tests show that this impact will change the configuration of spatial-temporal resources at intersections.Compared with the conventional lane-based model, the modified model can significantly improve the intersection maximum capacity while ensure safe flow propagation. The improvement on the intersection maximum capacity increases with the heavy vehicle proportions and the impact of lane location on travel efficiency. But with the increase of the difference of travel efficiencies between heavy vehicles and passenger cars, the improvement first increases and then decreases.

Increasing the Capacity of Intersections With Special Width Approach Lanes

Modeling Capacity at Signalized Intersections with a Left-Turn Storage Bay Considering Signal Timing Plan

Configuration of Spatial-temporal Resources at Intersections Considering Travel Efficiencies of Mixed Flows

Increasing the Capacity of Signalized Intersections by Allocating Exit Lanes to Turning Movements

Integrated Control of Internal Boundaries and Signal Timing at An Isolated Intersection for Lane-Free Traffic of CAVs.

Integrated Control of Internal Boundary and Ramp Inflows for Lane-free Traffic of Automated Vehicles on Freeways.

Capacity of Urban Arterial Weaving Sections under Lane Signal Control Strategy

Modeling Capacity of Shared Right-Turn Lanes at Signalized Intersections Considering the Lag Green Time of Right-Turns

Intersection control strategy optimization based on exchangeable lanes modeling

An Integrated Capacity Optimization Model Based on Two Unconventional Intersections

Modeling capacity of shared right-turn lanes considering right turn on red and lag green time of right-turn

Traffic Signal Coordination Control for Arterials with Dedicated CAV Lanes

Offset Optimization Based on Queue Length Constraint for Saturated Arterial Intersections

Optimization Method of Signal Timing Parameters Considering Comprehensive Efficiency of All Approach Lanes

Maximum cycle length optimization method of signalized intersection

Passing Capacity of Advance Right-Turn Motor Vehicles

Influence of signal on the capacity of signalized intersection

The Impact of Vehicle Lane Changing Behavior on Road Capacity Based on VISSIM Simulation

Optimization of Variable Approach Lane Use at Isolated Signalized Intersections

A Signal Coordination Model for Long Arterials Considering Link Traffic Flow Characteristics

Capacity of unsignalized intersection with mixed distribution headway