Abstract:The accuracy and precision of clock synchronization plays an important role in synchronized pseudolite systems. Though the atomic clock is a favorable choice for time-keeping application, the crystal oscillator is obviously more desirable in view of the cost. Due to the lower stability and accuracy of crystal oscillators, additional approaches for frequency transfer and time offset calibration are required for a pseudolite network, and approaches based on wireless links are very desirable for their convenience.However, due to the immobility of pseudolites and complicated wireless environments, the measurements unavoidably contain constant errors, such as the multipath error and the tropospheric delay. From a global perspective, if pseudolites are able to receive signals from multiple other pseudolites, there will be more information available to mitigate the influences of errors mentioned above, which is a motivation of this work. The measurements are collected from the whole network, and the clock offsets of all pseudolites are estimated together. Moreover, in our approach, the pseudolite use all received signals to compute the frequency correction for itself.Also, the robustness is considered and relevant improvements are discussed in this paper. In harsh environment, the Least-Square estimation may be severely deteriorated by abnormal measurements of large bias. We put forward an alternative method by using robust estimator. By feat of the measurements from the whole network, Lorentzian estimator is involved to automatically mitigate their bad influences and improve the robustness of our approachThe paper describes the main procedure of the network-based synchronization approach. Its performance is verified based on results of Monte-Carlo simulations. Simulation results show that when no abnormal signals are involved, the Lorentzian estimator will obtain a suboptimal estimation with a slightly worse performance than Least-squares (LS). However, it significantly outperforms LS estimation under the influence of abnormal signals. We also discuss the selection of parameters for the Lorentzian estimator and the influences on the final performance. The precision of the proposed frequency transfer approach which combines signals from multiple pseudolites is verified as well.

Pseudolites Pulsed Signals to Near-Far Problem and Compatibility

A Near-Far Effect Mitigation Method of Pseudolites Based on Array Signal

An Improved Navigation Pseudolite Signal Structure Based on the Kasami Sequences and the Pulsing Scheme

Direct Position Acquisition for Pseudolites Positioning System with Near-far Resistance

Simulation Analysis and Study of Signal Acquisition of GPS Pseudolite

Double radio frequency channel-based near-far effect mitigation

Positioning for a Spacecraft using Pulsars

Analysis and simulation of the GPS-Pseudolite signals

Analyses of Noncommensurate Sampling Used in High-Precision Regenerative Pseudo-Noise Ranging Systems

An Improved Pseudolite-Based Indoor Positioning System Compatible With Gnss

Time synchronization requirement of global navigation satellite system augmentation system based on pseudolite

Urban Environment Solutions to GPS Signal Near-Far Effect

High accuracy and fast acquisition algorithm for pseudolites-based indoor positioning systems

Pseudolite system-augmented GNSS real-time kinematic PPP

A High Accuracy Time Keeping Scheme Based on GPS

A New Network-Based Synchronization Approach for Pseudolite and Improvements on Robustness

An Optimized Transmission Power Control Method for Pulsed BeiDou Pseudolite Signals

A New Coupled Method for Pseudolite System-Augmented GNSS Real-Time Kinematic PPP

Effective Pps Signal Generation with Predictive Synchronous Loop for Gps

A PSO-Based Layout Method for GNSS Pseudolite System

A Design Scheme of Indoor Pseudolites Positioning System Based on Carrier Phase