Characteristics of Surface Electromyography Single Change Based on Isokinetic Muscle Fatigue

YANG Hong-chun,WANG Jian,WANG Du-ming

DOI: https://doi.org/10.3969/j.issn.1000-677x.2005.07.003

2005-01-01

Abstract:To investigate surface electromyography feature based on isokinetic exercise condition.12 male subjects performed isokinetic contractions of elbow flexion and extension at 180°/sec for 40 times.SEMG signal of bicep brachii and flexion peak torques were sampled.The author separated flexional and extensional signal from raw sEMG and then reassembled the two kinds of signal.The linear parameter AEMG,MPF and non-linear parameter C(n),DET% were calculated in the respect of raw signal,assembled flexional and extensional signals.The result showed that the assembled flexion and extension sEMG signal could be seen as stationary signal basically.The correlations between MFP,C(n),DET% of flexion sEMG signal and peak torques were higher than those between raw sEMG signal and peak torques.C(n) of bicep brachii was lower as agonist muscle than that as antagonist muscle.Conventional continuously analysis method to static sEMG signal was unsuitable for analysis of non-stationary signal.Proper separation and reassembling would be expected to get more accurate results.