Abstract:The bentonite/sand mixture is an optional buffer/backfill material in the geological disposal of high level nuclear waste. Understanding the volume change characteristics of this mixture under coupled hydro-mechanical condition is highly significant for evaluating the long-term safety of the repository. In this investigation, six groups of bentonite/sand mixtures were prepared with different contents of quartz sand, i. e. 0%, 10%, 20%, 30%, 40% and 50%. Then a series of experiments including uniaxial confined compression (to a final dry density of 1.7 Mg/m(3)), saturation (under 0.2 MPa vertical pressure) and reloading tests was carried out in sequence. The volume change behavior of bentonite/sand mixtures was understood, in addition, the effect of sand content was also analyzed emphatically. It is found that: (1) The compression behaviour of mixture significantly depends on sand content, saturation state and density. As the mixture is unsaturated and at relative low dry density (rho(d) < 1.7 g/cm(3)), the compression index decreases linearly with increasing sand content. However, as the mixture is saturated and at relative high dry density (rho(d) < 1.7 g/cm(3)), the compression index of mixture is independent of sand content, and the corresponding value is much less than that at unsaturated and loose state. (2) The final swelling strain of the mixture decreases exponentially with increasing sand content, while increases exponentially with effective bentonite dry density. As the sand content in the mixture is higher than 40%, volume collapse can occur during saturation, and collapse extent is enhanced by increasing sand content. (3) The observed volume change characteristics of the mixture under different hydro-mechanical conditions or at different sand contents are mainly related to the distribution of bentonite and sand in the mixture, and their dominant effect on soil skeleton. Generally, the higher sand content and higher density, the volume change behavior the mixture is more conditioned by sand. (4) The swelling pressure of mixture decreases with increasing sand content. A parameter terms as "effective bentonite dry density" is introduced to quantitatively describe the swelling pressure of the mixture, and an exponential relationship between these two parameters is developed which can be used to predict mixture swelling pressure. Moreover, the swelling mechanism of bentonite/sand mixture is further analyzed based on volume change ratio and mass distribution ratio of montmorillonite in the mixture. In conclusion, this work is a reference for the selection and performance optimization of buffer/backfill materials.

Assessment of workability for soil-bentonite slurry-trench cutoff walls

Hydraulic Conductivity of Compacted Manufactured Sand Tailings–bentonite Mixtures: a New Hydraulic Barrier Material

Test and analysis of hydraulic conductivity of geosynthetic clay liners overlap in vertical barrier wall

Engineering Characteristics and Microscopic Mechanism of Soil–Cement–Bentonite (SCB) Cut-Off Wall Backfills with a Fixed Fluidity

Consolidation Behaviors of Soil-Bentonite Slurry Trench Cutoff Walls: a Large-Scale Test

Assessment of membrane and diffusion behavior of soil-bentonite slurry trench wall backfill consisted of sand and Xanthan gum amended bentonite

Saturated Hydraulic Conductivity of Compacted Steel Slag-Bentonite Mixtures--a Potential Hydraulic Barrier Material of Landfill Cover.

Numerical Analysis of Consolidation Behavior of Soil-Bentonite Backfill in a Full-Scale Slurry Trench Cutoff Wall Test

Hydro-mechanical behavior and microstructure evolution of red clay-bentonite backfills

Centrifuge Modeling of Backfill Consolidation in Soil-bentonite Cutoff Walls

Non-monotonic Piezocone Dissipation Curves of Backfills in a Soil-Bentonite Slurry Trench Cutoff Wall

Enhanced Organic Contaminant Retardation by CTMAB-Modified Bentonite Backfill in Cut-Off Walls: Laboratory Test and Numerical Investigation

Field test on the stress state and consolidation behavior of soil-bentonite cutoff walls

Experimental Simulation of Boundary Condition Effects on Bentonite Swelling in HLW Repositories

Site water salinity effect on the hydro-mechanical behavior of compacted GMZ bentonite with technological void

Hydraulic conductivity and compressibility of polyanionic cellulose-modified sand-calcium bentonite slurry trench cutoff wall materials

Physical Modeling Study on Treatment of Waste Slurry with Vacuum Preloading at Bottom Combined with Upper Surcharge Loading

Comparative research on the application of slag as an alternative to cement in binder-bentonite cutoff wall backfills

Volume change characteristics of bentonite-sand mixture under hydro-mechanical coupling condition

A Preliminary Study on the Improvement of Gangue/Tailing Cemented Fill by Bentonite: Flow Properties, Mechanical Properties and Permeability

Force Equilibrium–Based Model for Predicting Stresses in Soil-Bentonite Cutoff Walls