Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

Simulation of Flow in Continuous-Flow Cloud Condensation Nuclei Counter (DMT-CCNC)

Numerical Simulation and Experimental Study of Capillary Tubes

Numerical Simulation of Gases over Flat Plate Using Two-Temperature Nonlinear Coupled Constitutive Relations

Numerical Investigation on Local Non-equilibrium Flows Using a Diatomic Nonlinear Constitutive Model

Numerical Analysis of the Micro-Couette Flow Using a Non-Newton–fourier Model with Enhanced Wall Boundary Conditions

Computation of Hypersonic Flows over Flying Configurations Using a Nonlinear Constitutive Model

Numerical Simulation of Hypersonic Thermochemical Nonequilibrium Flows Using Nonlinear Coupled Constitutive Relations

Experimental Validation of Nonlinear Coupled Constitutive Relations in Continuum Flows

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Simulation of Flow and Heat Transfer in Micro Couette Flow

Simulation of Condensation Flow in A Rectangular Microchannel

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Numerical simulation of condensation in microchannels between spherical particles

Numerical Simulation Of Heat And Mass Transfer In Air-Water Direct Contact Using Computational Fluid Dynamics

Numerical Investigation of Convective Condensation with the Presence of Non-Condensable Gases in A Vertical Tube

Numerical study on thermal transpiration flows through a rectangular channel

Numerical Simulation of Condensation for R410a in Horizontal Round and Flattened Minichannels

Numerical Simulation Studies on Multiphase Flow in High Temperature Wind Tunnel Contractions and Experimental Sections

Numerical Simulation of Condensation for R410A at Varying Saturation Temperatures in Mini/micro Tubes

Numerical simulation of single bubble condensation in subcooled flow using OpenFOAM

Homogeneous/heterogeneous Condensing Flow Modeling in Turbine Cascades