Grouting pressure of exponential fluids based on Navier-Stokes equation

ZHOU Zilong,DU Xueming,CHEN Zhao,ZHAO Yunlong

DOI: https://doi.org/10.11817/j.issn.1672-7207.2017.07.020

2017-01-01

Abstract:In order to study the pressure distribution and diffusion radius of slurry throughout fissure section,overcome the shortcomings that the average pressure of the fissure section was obtained by using the average speed,control the slurry flow and the range of diffusion accurately,the diffusion movement of exponential slurry in the horizontal fissures smooth tubular model was theoretically derived based on the Navier-Stokes equations of viscous fluid.Then the effects of law among the viscosity coefficient,rheology index,grouting time,the height of the fracture and diffusion radius or grouting pressure were mainly discussed,which provided theoretical basis for the grouting design of geotechnical fissure.The results show that when the viscosity is smaller,grouting diffusion radius is larger relatively.But the slurry viscosity reaches a certain degree,and the effect of filter is easy to occur under the constant grouting pressure.When the rheological index is smaller,pressure difference Ap has no obvious change.Exceeding a certain value,Ap shows a rapid increase of nonlinear along with the increase of rheological index.The grouting pressure of the interface between the flow core zone and non flow core zone is the maximum.The pressure shows a nonlinear decrease gradually away from the flow core zone (y direction),and then increases rapidly.But the pressure value is always less than the pressure of the interface between the flow core zone and non flow core zone until the crack boundary.With the increase of the grouting time,the diffusion radius of grouting increases with the trend of the non-linear.However,the increasing rate of the diffusion radius is gradually decreased and the diffusion radius tends to reach a certain value finally.