Optimization design of cold extrusion combined die for spur gear of camion

LIANG Qiang,ZHOU Jie,HE Xiong,XIA Zeyu,LIU Zhengwei

DOI: https://doi.org/10.11817/j.issn.1672-7207.2017.11.006

2017-01-01

Abstract:In order to improve the service life of cold extrusion combined die for spur gear of camion, the equivalent diameter of tooth shaped cavity, diameter ratio and shrink fitting ratio of combined die were taken as design variables, the Kriging model of effective stress and structure parameters of the combined die was built, which aimed at decreasing the effective stress of the die insert. The Kriging model combined with the particle swarm optimization were used to find the optimal structure size of combined die in the variable space. The optimal structure sizes of the combined die were as follows: die insert diameterD2=107.485 mm, middle layer diameterD3=187.215 mm, stress ring diameterD4=274.839 mm, unilateral radial shrink fitting between die insert and middle layerU1=0.134 mm, unilateral radial shrink fitting between middle layer and stress ringU2=0.253 mm. Meanwhile, the numerical simulation method was also used to simulate the forming process with the optimized combined die. The results show that the maximum effective stress on the inside of die insert is obtained and the value is 1870 MPa. The optimization method provides a method for the design of cold extrusion combined die for gears.