Separation of lignin and hemicelluloses from black liquor and pretreated black liquor by nanofiltration
J. Olsson
Abstract:Black liquor is a byproduct from the production of pulp and paper. Since Sweden to a large extent consists of forest it would be of great interest to use this byproduct for manufacturing of other products. Black liquor contains lignin and hemicelluloses which could be used for production of biofuel and plastics respectively. To separate these components from the black liquor, membrane filtration with ceramic membranes can be used. This study compares the efficiency of separation between ultrafiltration (UF) and nanofiltration (NF) with ultrafiltration as a pre-treatment. The results showed that a good separation of lignin and hemicelluloses from black liquor could be achieved with both methods. However, if a separation between lignin and hemicelluloses was the aim, ultrafiltration as a first step is required. The initial flux during NF increased almost 100 % (from 200 l/m 2 h to approximately 400 l/m 2 h) when the feed was permeate from ultrafiltration instead of untreated black liquor. The higher flux made it possible to reach a higher volume reduction which is desired. The results of the study show that separation of lignin and hemicellulose from black liquor is possible and that ultrafiltration as a pre-treatment has advantages compared to nanofiltration alone. Key-words: Nanofiltration, black liquor, membrane, lignin, hemicelluloses Introduction The energy demand of the world is increasing daily and today 30 % of the consumed energy is derived from fossil fuels such as oil, coal and natural gas [1]. Since the resources of these fuels will come to an end and the prices are increasing, it is important to find renewable, cheaper energy sources to meet the increasing demand [1]. Sweden is a country that is, to a large extent, covered in forest. Consequently, products from the forest industry equal 11 % of the total value of exported goods [2]. From the forest the most used raw material is wood and the largest part of the industry itself is the production of pulp and paper [3]. In the making of pulp, the wood is debarked and chopped and then fed to a digester [4]. Here, chemicals are added at a high temperature to separate the fibers from other components of the wood such as lignin, hemicelluloses and extractives [4]. From the digester two streams are obtained, of which one is rich in fibers. This stream is later washed, bleached and dried to get pulp. The other stream is black liquor [4], which is sent to a recovery boiler where the cooking chemicals are regenerated and the organic material is burnt to produce heat and power [5]. Since black liquor contains both hemicellulose and lignin which could be used to produce plastics and biofuels, a separation of this two components from the black liquor would be of interest [6]. The purpose of this study was to separate lignin and hemicelluloses from the black liquor by using membrane filtration. Materials and method Black liquor The black liquor used in this project was softwood black liquor from Södra Cell pulp mill in Mönsterås, Sweden. It was extracted directly after the digester and thus no chemicals for bleaching have been added. The composition of the black liquor used is presented in table 1. Table 1 Composition of the black liquor used. Total lignin 61,4 mg/g Acid-insoluble lignin 53,9 mg/g Acid-soluble lignin 5,03 mg/g Total dry substance 147 mg/g
Chemistry,Materials Science,Engineering,Environmental Science