Abstract:Microvibration induced by natural disturbance and human activities has an adverse effect on the operation of the large-scale and ultraprecise facilities in the world. Under such circumstances, a passive vibration control method is generally deployed for such vibration-sensitive facilities, taking the High Energy Photo Source (HEPS) in Beijing as an example, a 3 m-thick mass concrete layer forming a ring foundation was cast at the facility, where a 1 m-thick reinforced concrete slab (RC slab) lies. Since microvibration control plays a crucial role in the operation of such large-scale scientific and ultraprecise facilities and few studies have been reported for large-scale concrete layer as antimicrovibration devices, this paper presents four field tests in Beijing, China, to evaluate the vibration control capacity of a mass concrete layer. Based on a large number of field tests, the effect of applying the concrete layer is discussed, and a reference is provided for the construction of similar facilities. The vibration signals, generated by shock excitation and ambient excitation, are measured through a highly sensitive and high-accuracy vibration acquisition system. It is concluded that the existence of the 1 m-thick RC slab has little influence on the microvibration signal frequency distribution in the vertical direction and that the signals from the concrete layer and subsoil differ by approximately 10 Hz in the vertical direction while differing by approximately 5 Hz in the horizontal direction. The microvibration control ability of the concrete layer is favorable in a higher frequency band over 20 ~ 30 Hz and more than 50% attenuation can be gained through the concrete layer; however, the microvibration control ability is not significant below 20 ~ 30 Hz. The vibration levels across different heights of the concrete layer section are the same. To prevent adverse vibration disturbance below 20 ~ 30 Hz, it is suggested that the traffic and road surface conditions should be taken into consideration when choosing the construction location. In addition, a long-term monitoring shows that 75% vibration energy at the site is firmly related to the construction activities which are approximately 1.4 km from the site.

Experimental study on ultrasonic wave velocity change of fresh concrete under multiple vibration loadings

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

An improved ultrasonic coda wave method for concrete behavior monitoring under various loading conditions

Study on Ultrasonic Nondestructive Testing of Self-Compacting Concrete under Uniaxial Compression Test

Study of the Healing Effect of Concrete with Supplementary Cementitious Materials after Early-Age Damage by Acoustic Emission Technique

Prediction of Ultrasonic Pulse Velocity for Cement, Mortar, and Concrete Through a Multiscale Homogenization Approach.

Experimental Study on Dynamic Characteristics of Saturated Soft Clay with Sand Interlayer under Unidirectional and Bidirectional Vibration

Temperature‐Dependent Modulus and Ultrasonic Velocity of Concrete

A novel ultrasonic-velocity-based concrete carbonation monitoring method based on step-wise stretching technique

Further numerical investigation on concrete dynamic behaviors with considering stress non-equilibrium in SHPB test based on the waveform features

Creep Characterization of Concrete Suffering Initial Damage

Study of Magnetically Driven Concrete

Study on Natural Frequency of Concrete Floor Based on Vibration Serviceability

An experimental and numerical investigation of coarse aggregate settlement in fresh concrete under vibration

Study on Vibration-Damping Blasting Technique for Early-Age Concrete

Field test study on the evaluation of the microvibration controlling capacity of a mass concrete layer

Effect of vehicle-induced vibration on the strength, nano-mechanical properties, and microstructural characteristics of ultra-high-performance concrete during hardening process

Experimental study on loading rate and notch-to-depth ratio effects on flexural performance of self-compacting concrete with acoustic emission and digital image correlation technologies

Study on wave velocity characteristics and compressive strength of concrete under different water pressure

Simulations of ultrasonic wave propagation in concrete based on a two-dimensional numerical model validated analytically and experimentally

Field test study for evaluation of vibration control capacity of cracked mass concrete layer