Abstract:In order to investigate the variations of surface microstructure and extract composition of tobacco stems and scraps extracted by different solvents, the influence of solvent types on the leaf surface properties and extract aroma components were compared by taking water, ethanol water solution and potassium carbonate solution as the extraction media. The results showed that: 1) The extraction ratios of water and ethanol water solution did not differ significantly, and the appearance of extracted stems and scraps did not change significantly. However, the extraction ratio of potassium carbonate solution was lower, the extracted stems and scraps became dark black, deformed and stuck together. 2) After water extraction, the tissue structure of stems became microporous with obvious pores; the collenchyma of stems became poriferous, the vessel structure of stems was partially detached and deformed after extraction with ethanol water solution. More vessels were damaged and the volume reduced after extraction with potassium carbonate solution. After water or ethanolwater solution extraction, there were many small wrinkles in the surface of scraps, the microscopic variation was obvious. The surface of scraps extracted by potassium carbonate solution changed somewhat, there was only a few uplifts, the reduction of filler was small, and the difference with the original scraps was not obvious. 3) The main extract components of stems and scraps in different solutions were nicotine. Extraction with ethanol water solution was found benefit for the extraction of aroma components, alcohols and ketones, while potassium carbonate solution reacted with lignin which resulted in the discoloration and staleness of material, therefore it was not a suitable extraction process, despite the fact that it promoted the dissolution of a large amount of anatabine.

Supercritical CO2 Fluid Extraction of Natural Flavor Components in Tobacco Stem

Extraction Technology of Tobacco Absolute Oil by Compound Solvent

Application of Response Surface Method to Optimize Purification of Tobacco Stem Extract by Molecular Distillation

Study on Flavor Components Technical Optimization and Flavor Characteristics for Supercritical Carbon Dioxide Extraction of Tobacco Powder

GC-MS/MS Analysis of Chemical Constituents of Essential Oil from Tobacco with Supercritical Fluid Extraction

Extracting Waste Tobacco with Ethanol-Water Solution

Optimization of Extraction Technology of Nicotine from Waste Tobacco Leaves by Supercritical CO2

Optimization for the Extraction of Active Ingredients from Tobacco Leaves by RSM

Extraction of Nicotine in Tobacco with Ultrasonic Supercritical CO_2 Fluid

Understanding and Improving Supercritical CO_2 Extraction of Solanesol and Optimization of Process

Supercritical Fluid CO2 Extraction of Herba Moslae L.and Its Application in Tobacco

Extraction of Essential Oil from Discarded Tobacco Leaves by Solvent Extraction and Steam Distillation, and Identification of Its Chemical Composition

Selection of Methods of Aroma Components Extraction from Tobacco Flavor

Nontarget Analysis of Natural Flavor Metabolites in Tobacco Extracts

Studies on three-stage counter current extraction of tobacco stem and tobacco dust

Extraction and Purification of Nicotine from Tobacco Rhizomes by Supercritical CO2

Optimization of the Technology of Supercritical CO_2 Extraction Solanesol from Tobacco Leaves

Supercritical CO2 Extraction and Application of Aroma Constituents in Tea, Hunan Maojian

Variations of surface microstructure and extract composition of tobacco stems and scraps extracted by different solvents

Optimization of Ultrasonic-Assisted Extraction of Chlorogenic Acid from Tobacco Waste

Study on Extraction of Nicotine from Tobacco by Supercritical CO2