Abstract:The structure of a low-power 16 bit by 8 bit two's complement multiplier unit in the design of a DSP (digital signal processor) chip was proposed based on standard cell. The multiplier used modified Booth's algorithm to generate the partial products, a Wallace tree structure to achieve the high-speed partial products addition, and finally, a high speed carry lookahead adder to finish the carry propagation. The delay of the carry propagation plays a very important role in the whole delay of the multiplier. To solve this problem, the LRCF (left-to-right-carry-free) algorithm was applied to complete the MSB (most significant bits) result calculation partially parallel with the Wallace tree addition. The power consumption distribution within this multiplier was analyzed and some methods were applied to reduce the switching activity of the Wallace tree structure to reduce the power consumption. Based on the UMC 0.18 μm CMOS technology standard cell library, the reports of Design Power showed that the multiplier can achieve the speed of 2.80 ns, an average dynamic power dissipation of 0.089 mW/MHz at 1.62 V and 125°C.

Design of Double-Edge-triggered Monostable Multivibrator

Research on Applications of Monostable Trigger 74121

Design of Low Power Multivalued Double-Edge-triggered Flip-Flop

Design of a New Trigger Circuit for Three-phase Semicontrol Bridge

Design of clock edge controllable dual edge-triggered flip-flop and its application

A General Structure Of All-Edges-Triggered Flip-Flop Based On Multivalued Clock

Voltage-Mode Multi-Valued Schmitt Trigger with Neuron-MOS Transistors

Multi-valued Logic Design Methodology with Double Negative Differential Resistance Transistors

Minimizing Multiple Triggering Effect in Diode-Triggered Silicon-Controlled Rectifiers for ESD Protection Applications

The Phase-locked Frequency Multiplication Application in Automatic Register Controller System

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Design of CMOS low-power pre-settable edge-triggered flip-flop based on multithreshold technique.

Design of low-power and high-speed multiplier

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

An Explicit-Pulsed Double-Edge Triggered Jk Flip-Flop

Improved Marx Pulse Generator With Auxiliary Trigger Topology (2022)

Structure and Design Method for Pulse-Triggered Flip-Flops at Switch Level

Design of Double Time Base System for Digital Storage Oscilloscope

A New Algorithm for SCR Digital Trigger:Double Remainder Method

Development of a Marx-coupled Trigger Generator with High Voltages and Low Time Delay.

Design of Simple Digital Oscilloscope Based on Double MCU