Abstract:Bismuth ferrite nano‐ and microcrystals were prepared by a facile molten salt technique in two kinds of molten‐salt‐based systems (NaCl–KCl and NaCl–Na2SO4). In the NaCl–KCl salt system, a systematic study indicating the effects of process parameters (e.g., calcination temperature, holding time as well as the molten salt ratios) on the bismuth ferrite formation mechanism and structural characteristics is reported. The results show that almost pure phase BiFeO3 powders with minimum impurity phase of Bi2Fe4O9 were synthesized at temperatures of 700°C–800°C, whereas high calcination temperature (e.g., 900°C) resulted in the formation of almost pure phase Bi2Fe4O9 powders. The prolonged holding time increased the particle size via the Ostwald ripening mechanism; however, there was little effect on the particle morphology. Similar phenomenon occurred as increasing the molten salt ratios. In the NaCl–Na2SO4 salt systems, it is found that low NP‐9 (nonylphenyl ether, NP‐9) surfactant content (0–5 mL) led to the formation of almost pure phase BiFeO3 powders, whereas high NP‐9 surfactant content (e.g., 20 mL) resulted in pure phase Bi2Fe4O9 powders. The average particle size of the BiFeO3 powders was decreased as increasing the NP‐9 surfactant content, whereas their morphologies did not change significantly. Because of the simplicity and versatility of the approach used, it is expected that this methodology can be generalized to the large‐scale preparation of other important transitional metal oxides with controllable sizes and shapes.

Effects of Process Parameters on Bi4 Si3 O12 Powders Synthesized by Molten Salt Method

Molten salt synthesis of Bi2SiO5 powders based on uniform experiment

Synthesis of Pure Bi<sub>12</sub>SiO<sub>20</sub> Powder by Molten Salt Method

Effects of process parameters on nonhydrolytic sol-gel synthesis of Ba0.6Sr0.4TiO3 powders

Effects Of Electrolytic Parameters On The Deposition Of Boron At The Cathode During Molten Salt Electrolysis Of Silicon

Synthesis, microstructural characterization, and dielectric properties of BiFeO3 microcrystals derived from molten salt method

Effect of synthesis method upon the dielectric properties of SrBi2Ta2O9

Effect Of Sb2o3 On Thermal Properties Of Glasses In Bi2o3-B2o3-Sio2 System

Study of the synthetic process of CaBi2Ta2O9 powder by the molten‐salt method

Molten Salt Synthesis of Bismuth Ferrite Nano‐ and Microcrystals and Their Structural Characterization

THE PREPARATION OF SrBi2O4 AND EFFECTS OF TEMPERATURE ON ITS PHOTOCATALYTIC ACTIVITY

Molten-salt Synthesis of BaTiO3 Powders and Their Atomic-Scale Structural Characterization

Effect of solid-state reaction synthesis temperature of SrBi 2Ta2O9 on its sintering behavior

Effect of solid-state reaction synthesis temperature of SrBi2Ta2O9 on its sintering behavior

Effect of the Sintering Temperatures on the Properties of the Ca0.6Sr0.4Bi4Ti4O15 Ferroelectric Ceramics

Microstructures and properties of (65-x)SiO2-xBi2O3-10B2O3-25CuO glasses

Effect of co-precipitation synthesis parameters on gadolinium aluminate nanoparticles

Effect of Bi2O3 content on the structure and properties of Bi2O3-B2O3-BaO-ZnO glass

New Insights into the Synthesis of Sillén–Aurivillius Oxyhalides: Molten Salt induces Interlayer Halogen Competing Reaction

The Effect of Ba 2+ Doping on the Structure of SrBi 4 Ti 4 O 15

Effects of Sulfur Substitution for Oxygen on the Thermoelectric Properties of Bi2O2Se