Content determination of main fatty acid in Seal Oil Based Lipid Emulsion for parenteral nutrition by GC
SU Jianfen,JIANG Guisheng,GUO Zhefei,ZHUO Shitian,DONG Yixuan,WU Chuanbin
DOI: https://doi.org/10.3969/j.issn.1673-7210.2011.12.028
2011-01-01
Abstract:Objective:To establish a GC method for determining the content of main fatty acid(FA) in seal oil based lipid emulsion(20%) for parenteral nutrition,including myristic acid,palmitic acid,palmitoleic acid,oleic acid,arachic acid,EPA,DPA,DHA.Methods:Find out the best method among three esterification methods,comprising boron trifluoride esterification,methanol-potassium hydroxide esterification under room temperature and methanol-sodium hydroxide under heated condition.HP-InnoWax column(30 m×0.320 mm,0.25 μm) and FID were used,calibration curve method was employed to quantify.The injector and detector temperature were 220℃ and 280℃ respectively.The initial temperature was kept at 155℃ for 1 min,then raised to 205℃ at the rate of 25℃/min,again to 235℃ at the rate of 1℃/min,finally to 250℃ at the rate of 3℃/min and maintained the temperature for 5 min.Flow rate was set at 2 ml/min.Results:Esterification under room temperature was considered to be the best method.Among the eight main FA,this emulsion had a highest content of oleic acid(7.2%) and the lowest content of EPA(0.9%),the contents of the other six FA were between 1.3%-5.8%.The linear range of all the main FA was between 0.009 973-10.322 mg/ml.The average recovery were all between 98.4%-101.2%,and RSD were all less than 2.0%(n=3).Conclusion:The method is simple,accurate and reproducible.It may be adopted for the quality control of seal oil based lipid emulsion(20%) for parenteral nutrition.