Abstract:Flexoelectricity is known as an electromechanical gradient coupling effect. The direct flexoelectric effect that can convert mechanical strain gradient into electric polarization (or electric field) plays an important role in charge generation in the situation when piezoelectricity is absent. This study focuses on the application of the direct flexoelectric effect based on a flexoelectric cantilever beam to investigate its effectiveness of sensing signal and energy generation. The dielectric cantilever beam is deposited with electrodes both on top and bottom surfaces to generate an electric voltage. The sensing mechanism of flexo-piezo-electric effect is analyzed and the expression of sensing signal is derived. Results show that the output sensing signal is only contributed by the flexoelectric effect while the piezoelectric effect is eliminated due to the symmetric bending strains through the beam thickness. The spatial distribution of sensing signal when the fully covered electrode is uniformly segmented to 10 patches is evaluated as an illustration, and the flexoelectric sensitivity of about 0.15V/mm for the first mode and 4V/mm for the fourth mode is achieved. The optimal sensing position is dependent of the electrode size and the vibration mode and in general, it locates where the difference between the slopes at two ends of the electrode patch reaches maximum. Based on the flexoelectric voltage, the energy generation power is also conducted when the flexoelectric cantilever beam is treated as distributed energy harvesters. As a result, the maximal power of RMS is about 1.5x10(-8)W/mm for the first mode and increases to about 0.6mW/mm for the fourth mode. It provides an alternative way to harvest electric energy from the ambient vibration without using piezoelectricity.

Electrode Location Efficiency and Equivalent Circuit for Flexure Vibration of Piezoelectric Beam

Flexure Vibration Equation of Piezoelectric Beam and Calculation of Equivalent Volume Force

Sensing Signal And Energy Generation Analysis On A Flexoelectric Beam

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Investigation of the electric response of the piezoelectric curved beam considering the direct piezoelectric and flexoelectric effects

Mechanical Analysis on Extensional and Flexural Deformations of a Thermo-Piezoelectric Crystal Beam with Rectangular Cross Section

Vibrating Flexoelectric Micro-Beams As Angular Rate Sensors.

Finite Difference Based Electrical Modeling and Vibration Control Simulation of Piezoelectric Structronic Plate System

Forced vibration of piezoelectric and flexoelectric Euler–Bernoulli beams by dynamic Green’s functions

An analytical and meshless modeling for vibration analysis of an infinite quartz resonator with non-circular electrodes

Development of V-Shaped Beam on the Shock Resistance and Driving Frequency of Micro Quartz Tuning Forks Resonant Gyroscope

Bending and Vibration Analysis of Flexoelectric Beam Structure on Linear Elastic Substrates

Method for QCM Resonator Device Equivalent Circuit Parameter Extraction and Electrode Quality Assessment

Flexoelectric Effect on Vibration of Piezoelectric Microbeams Based on a Modified Couple Stress Theory

Electromechanical Analysis of a Beam Piezoelectric Transducer Energy Harvest Device

Elastic, piezoelectric coefficients, and internal frictions of a single alpha-quartz crystal determined by partial-electrode electromechanical impedance spectroscopy

Size-dependent thermal-electro-mechanical behaviors of a piezo-flexoelectric micro-beam based on nonlocal strain gradient theory and dual-phase-lagging heat model

Vibration Analysis of a Unimorph Nanobeam with a Dielectric Layer of Both Flexoelectricity and Piezoelectricity

Research on reference vibration for a two-axis piezoelectric micro-machined gyroscope

Analysis of Multilayered Two-Dimensional Decagonal Piezoelectric Quasicrystal Beams with Mixed Boundary Conditions

One-dimensional Dynamic Equations of a Piezoelectric Semiconductor Beam with a Rectangular Cross Section and Their Application in Static and Dynamic Characteristic Analysis