Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Flexoelectric Actuation and Vibration Control of Ring Shells

Flexoelectric Actuation and Control of Conical Shells

Multiflexoelectric Actuation and Control of Beams

Flexoelectric Responses of Circular Rings

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Actuation of Flexoelectric Cylindrical Shell Panel with Line Electrodes

Flexoelectric Signals On Rings In Transverse Motions

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Dynamic Analysis of Flexoelectric Actuated Truncated Conical Shells

Modal Signal Analysis of Conical Shells with Flexoelectric Sensors

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Comparison of Flexoelectric and Piezoelectric Dynamic Signal Responses on Flexible Rings

Distributed Multi-Flexoelectric Actuation and Control of Plates

Comparison of flexoelectric and piezoelectric ring energy harvester

A Hybrid Photovoltaic/flexoelectric Actuation Mechanism Applied to Precision Actuation and Vibration Control of Beams

Structronics and Actuation of Hybrid Electrostrictive/Piezoelectric Thin Shells

Vibration control with the converse flexoelectric effect on the laminated beams

Distributed Flexoelectric Modal Signals on Circular Cylindrical Shells

Micro-Photodeformation Actions of Photostrictive Actuator Patches Applied to Vibration Control of Cylindrical Shells

Micro-Structronics and Control of Hybrid Electrostrictive/Piezoelectric Thin Shells