Abstract:Applied with a large-scale direct shear apparatus,the 3D stress-controlled cyclic behavior of a gravel-structure interface was investigated and the influence of the shear path and stress amplitude was discussed.The tests were performed at normal stress of 400 kPa in two-way cross,one-way and two-way circular cyclic shear paths.Results indicate that:(1) The volumetric change of interface between coarse grained soil and structure can be divided into reversible and irreversible components in two-way cyclic shear paths.(2) Irreversible increment is dominant in the first few shear cycles,and then equivalent to reversible component which finally becomes the governing part of interface volumetric increment;but the volumetric change of interface gives priority to irreversible component.(3) Tangential displacement migrates with shear cycles.Interface exhibits non-coaxial behavior in the tangential direction for circular shear tests;tangential displacement amplitude and increment per shear stress decrease with shear cycles when the shear stress amplitude is relatively small.(4) With the increasing shear stress amplitude,non-coaxial angle decreases and tangential displacement and tangential displacement increment per shear stress both increase.Non-coaxial angle varies little with shear cycles in one-way circular shear path,while it has opposite algebraic sign at neighboring shear cycles in two-way circular shear path.(5) Tangential stress-tangential displacement curves present an elliptical shape in circular path and hyperbolic in cross shear path.Shear path and shear stress amplitude have notable influence on the 3D stress-controlled cyclic behaviors of interface.

INVESTIGATION OF INTERFACE PROBLEMS CONSIDERING THE EFFECTS OF ROTATION GRADIENTS

An Analysis of Interface Boundary Layers Based on the Couple Stress Theory

Numerical Simulations of Granular Material Behavior under Rotation of Principal Stresses: Micromechanical Observation and Energy Consideration

Boundary Layers Near Interfaces under Torsion

Effects of Shear and Rotation on the Mechanical Behaviour of Interphase

The Boundary Layer Solutions of the Interface Problem Considering the Strain Gradient

Study and Countermeasure on Side Effects from Principal Stress Axis Rotation Experiment with Hollow Cylinder Apparatus

Order of singularity and singular stress field about an axisymmetric interface corner in three-dimensional isotropic elasticity

Influence of the Earth Rotation on the Interfacial Wave Solutions and Wave-Induced Tangential Stress in A Two-Layer Fluid System

Logarithmic Singular Stress Field in an Interface Edge Consisting of Two Bonded Dissimilar Materials Subjected to a Concentrated Couple on Apex

Strain gradient near interface of coaxial cylinders in torsion

Stress Concentration Tensors of Inhomogeneities with Interface Effects

Investigation of Stress Intensity Factors for an Interface Crack in Multi-Interface Materials Using an Interaction Integral Method

Study on the Interface Parameters of Composite Materials with Consideration of the Effect of Thermal Stresses

On interface crack in laminated anisotropic medium

TEST INVESTIGATIONS ON 3D STRESS-CONTROLLED CYCLIC BEHAVIOR OF GRAVEL-STRUCTURE INTERFACE

Investigating the Behavior of a Griffith Crack at the Interface Between Isotropic and Orthotropic Elastic Half-Planes for the Opening Crack Mode

Investigation of the Behavior of a Griffith Crack at the Interface of a Layer Bonded to a Half Plane Using the Schmidt Method for the Opening Crack Mode

A Cracked Sliding Interface Between Anisotropic Bimaterials

Experimental study on 3D monotonic behavior of a gravel-structure interface considering initial shear stress

Thermal stresses in bilayer systems with weak interface