SIMULATION AND EXPERIMENTAL INVESTIGATION ON COUPLED STIFFNESS OF ROTATING SHAFT WITH TRANSVERSE CRACK
Jie QIN,XingMin REN,Xin GUAN,YongFeng YANG
DOI: https://doi.org/10.3321/j.issn:1001-9669.2009.04.007
2009-01-01
Abstract:Based on the finite element analysis and experimental analysis, stiffness of the cracked rotating shaft subjected to the coupling of axial, shearing, bending and torsion load is investigated, considered the influence of diversified factors. The FEM (finite element method) is used to model the cracked shaft. Six degrees of freedom are considered in each elemental node. Considering influence of coupling of shearing and bending load, full 6 × 6 stiffness matrix of cracked element is deduced. As the model is being meshed, d/l, a/R and the location relationship of loading point and crack position should be considered. Series responding curves have been calculated, which include both non-dimension stiffness and coupling stiffness by bending and axial load, the curves describe that, with the increase of depth of the crack shaft, the variation of non-dimensional stiffness of ξ direction is the most quickly; the peak D-value of the two non-dimensional stiffness for ξ and η directions occur at the depth of transverse crack varying in the small range of about 3 mm and 4 mm. With the increase of depth ratio of the crack shaft, the coupling stiffness by bending and axial load decrease; with the increase of slenderness ratio of the crack shaft, the coupling stiffness by bending and axial load increase. Simply supported rotating shaft with a middle transverse crack is used in the experiment. The 3-point bending experimental investigation is carried out, in order to obtain the stiffness data. Comparing the non-dimension stiffness curves of simulation calculation and experimental result, the simulation calculation tallied with experiment calculation preferably.