Modeling the method for determining the stimulated brillouin scattering threshold in a single-mode optical fiber
Berik Zhumazhanov,Ainur Zhetpisbayeva,Kairatbek Zhetpisbayev,Mereke Yerishova,Aray Tolegenova,Tansaule Serikov,Pavel Dunayev,Kanysh Nauryz,Kaini Kussainova,Gulzhazira Uristimbek
DOI: https://doi.org/10.15587/1729-4061.2022.253390
2022-02-25
Abstract:Nonlinear optical effects in optical waveguides play an important role in the development of fiber and integrated optics systems for optical communication and information processing. On the one hand, nonlinear effects impose restrictions on the radiation power that can be transmitted through an optical fiber or light guide. In this paper, the problem of the occurrence of the phenomenon from the stimulated Brillouin scattering (SBS) effect is investigated using two optical sources of rays in a single-mode optical fiber at joint waves of 1310 nm and 1550 nm. Due to the fact that in all trunk fiber-optic lines, the intensity and energy of input signals is limited due to the influence of SBS, methods are currently being sought to reduce the influence of this phenomenon. It was found that the energy of the input beam in the combined propagation of the compound did not reach the value of the threshold of SBS in the values of 25 dBm and 27 dBm due to the discrepancy between the experimental results and the results of the model. The SBS effect was not observed when the threshold threshold of 15 dBm and 27 dBm – SBS was reached when combining a dual beam along a single optical fiber in one direction. As a result, by double integration, the value of the SBS threshold was raised, and the direction for future scientific research was determined. If the possibility of increasing the threshold of SBS is proved, then increasing the distance of amplifiers in the main networks, respectively, its economic effect increases. In addition, it can be noted that there are no scientific papers devoted to the study of the effects of optical nonlinear effects by combining and distributing these two compounds along a single optical fiber. This article discusses the issues of improving the capacity and determination of the threshold for stimulated Brillouin scattering. To increase the power threshold is invited to consider the dependence of the phase modulation frequency of the spectral width of the laser radiation. In addition, the fact that the SBS threshold did not reach the value at an energy of 27 DB in the case of the double-beam distribution can be proved by discrepancies in comparison with the results of experimental studies and the results of the model that determines the SBS effect